Renault Ceres 65 (A) or VALMET 255 (255-4)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the Ceres 65 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 255 (255-4) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Renault Ceres 65 (A) suits loader and hydraulic implement work better on this data: 11% (290 kg / 639 lb) more three-point lift.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Renault Ceres 65 (A) and VALMET 255 (255-4), with the call on each
QuestionCeres 65 (A)255 (255-4)Call
Which puts more power through the PTO shaft?39.7 kW (53.2 hp)Traktorenlexikon, “Renault Ceres 65”39 kW (52 hp)Traktorenlexikon, “Valmet 255”Not comparableNot comparable on power at the PTO shaft: the Ceres 65 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 255 (255-4) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the Ceres 65 (A) and the 255 (255-4).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the Ceres 65 (A) and the 255 (255-4).
Which pumps more oil for implements?39.0 L/min (10.3 gpm)Traktorenlexikon, “Valmet 255”No figureNo call on hydraulic flow: no figure on record for the Ceres 65 (A).
Which lifts more on the three-point hitch?2,870 kg (6,327 lb)Traktorenlexikon, “Renault Ceres 65”2,580 kg (5,688 lb)Traktorenlexikon, “Valmet 255”AheadThe Renault Ceres 65 (A) has 11% more lift (290 kg / 639 lb) than the VALMET 255 (255-4) (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?2,850 kg (6,283 lb)Traktorenlexikon, “Renault Ceres 65”2,820 kg (6,217 lb)Traktorenlexikon, “Valmet 255”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?4,450 kg (9,811 lb)Traktorenlexikon, “Renault Ceres 65”No figureNo call on maximum permissible mass: no figure on record for the 255 (255-4).
Which has the wider choice of gears?9 to 10Traktorenlexikon, “Renault Ceres 65”8 to 12Traktorenlexikon, “Valmet 255”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the Ceres 65 (A) and the 255 (255-4).
Which is faster on the road?30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Renault Ceres 65”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Valmet 255”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Renault Ceres 65”540/1000 rpmTraktorenlexikon, “Valmet 255”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Valmet 255”No figureNo call on PTO independence: not stated for the Ceres 65 (A).
Which drives on both axles?2WD / 4WDTraktorenlexikon, “Renault Ceres 65”2WD / 4WDTraktorenlexikon, “Valmet 255”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1993–19951992–1994EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Renault Ceres 65 (A) has 11% more lift (290 kg / 639 lb) than the VALMET 255 (255-4) (both lift at the hitch ends, as stated by the source).
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the Ceres 65 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 255 (255-4) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources