7 material differences · fewer than 12
Tractor oneLanz D 70061943–1945No measured PTO figureTractor twoMAN AS 3251948–1955No measured PTO figure
Which should you choose?
Read our verdict on the D 7006 and the AS 325 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | D 7006 | AS 325 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 24.5 hp | 24.5 hp | — |
| Engine declared | — | MAN D 8814 GS ( ab 1950 = D 8814 f ) | — |
| Displacement declared | — | 2.68 L | — |
| Maximum torque declared | — | 101 lb·ft · 137 N·m | — |
| Transmission | |||
| Top speed declared | 9.4 mph · 15.1 km/h | 12.0–12.4 mph · 19.3–20.0 km/h | differs |
| Clutch declared | Pedal operated three-shoe clutch with clutch brake | Single-plate dry clutch | differs |
| Hydraulics & hitch | |||
| Rear PTO speeds declared | 850 | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,203 lb · 2,360 kg | 3,902 lb · 1,770 kg | +33% D 7006 |
| Maximum permissible mass declared | — | 5,952 lb · 2,700 kg | — |
| Wheelbase declared | 66.5 in · 1,690 mm | 71.7 in · 1,820 mm | +8% AS 325 |
| Length declared | 130.7 in · 3,320 mm | 118.7–123.2 in · 3,015–3,130 mm | differs |
| Width declared | 63.0 in · 1,600 mm | 62.6–66.1 in · 1,589–1,680 mm | — |
| Ground clearance declared | 13.0 in · 330 mm | 12.6–15.7 in · 320–400 mm | differs |
| Turning radius, braked declared | — | 8.2 ft · 2.50 m | — |
| Fuel tank declared | — | 44.4 qt · 42 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Lanz D 7006 sources
- Source: Traktorenlexikon, “Lanz D 7006 Reingas”
MAN AS 325 sources
- Source: Traktorenlexikon, “MAN AS 325”