6 material differences · fewer than 12
Tractor oneLandini 9800 (DT)1987–2000No measured PTO figureTractor twoSteyr 8110 (a)from 1984No measured PTO figure
Which should you choose?
Read our verdict on the 9800 (DT) and the 8110 (a) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 9800 (DT) | 8110 (a) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 88.8 hp | 88.8 hp | — |
| Engine declared | PERKINS LJ 4.236 | Steyr WD-611.43 | differs |
| Displacement declared | 3.86 L | 5.18 L | +34% 8110 (a) |
| Maximum torque declared | 242 lb·ft · 328 N·m | 238 lb·ft · 323 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Pedal-operated dry single-disc clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 13.5 gpm · 51.1 L/min | — | — |
| Pressure declared | 2,901 psi · 200 bar | 3,553 psi · 245 bar | +23% 8110 (a) |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,995 lb · 4,080 kg | 8,576 lb · 3,890 kg | — |
| Maximum permissible mass declared | 14,991 lb · 6,800 kg | — | — |
| Wheelbase declared | 96.9 in · 2,460 mm | 98.8 in · 2,509 mm | — |
| Length declared | 166.1 in · 4,220 mm | 163.4 in · 4,150 mm | — |
| Width declared | 81.9 in · 2,080 mm | 76.4 in · 1,940 mm | +7% 9800 (DT) |
| Ground clearance declared | 16.0 in · 407 mm | — | — |
| Turning radius, braked declared | — | 12.1 ft · 3.70 m | — |
| Fuel tank declared | 182.8 qt · 173.0 L | 128.9 qt · 122.0 L | +42% 9800 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Landini 9800 (DT) sources
- Source: Traktorenlexikon, “Landini 9800 DT”
Steyr 8110 (a) sources
- Source: Traktorenlexikon, “Steyr 8110”