Landini 5860 (DT) TL-22 N/K (TL-22 DT/K) or ZETOR 5211/5245?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 5860 (DT) TL-22 N/K (TL-22 DT/K) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 5211/5245 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Landini 5860 (DT) TL-22 N/K (TL-22 DT/K) suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Landini 5860 (DT) TL-22 N/K (TL-22 DT/K) and ZETOR 5211/5245, with the call on each
Question5860 (DT) TL-22 N/K (TL-22 DT/K)5211/5245Call
Which puts more power through the PTO shaft?34.6 kW (46.4 hp)Traktorenlexikon, “Landini 5860”34.6 kW (46.4 hp)Traktorenlexikon, “Zetor 5211”Not comparableNot comparable on power at the PTO shaft: the 5860 (DT) TL-22 N/K (TL-22 DT/K) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 5211/5245 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the 5860 (DT) TL-22 N/K (TL-22 DT/K) and the 5211/5245.
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the 5860 (DT) TL-22 N/K (TL-22 DT/K) and the 5211/5245.
Which pumps more oil for implements?37.9 L/min (10.0 gpm)Traktorenlexikon, “Landini 5860”59.0 L/min (15.6 gpm)Traktorenlexikon, “Zetor 5211”AheadThe ZETOR 5211/5245 has 56% more hydraulic flow (21.1 L/min / 5.6 gpm) than the Landini 5860 (DT) TL-22 N/K (TL-22 DT/K) (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?2,040 kg (4,497 lb)Traktorenlexikon, “Landini 5860”1,750 kg (3,858 lb)Traktorenlexikon, “Zetor 5211”AheadThe Landini 5860 (DT) TL-22 N/K (TL-22 DT/K) has 17% more lift (290 kg / 639 lb) than the ZETOR 5211/5245 (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?2,250 kg (4,960 lb)Traktorenlexikon, “Landini 5860”2,850 kg (6,283 lb)Traktorenlexikon, “Zetor 5211”Ahead (a fact, not an advantage)The ZETOR 5211/5245 is 27% heavier (600 kg / 1,323 lb) than the Landini 5860 (DT) TL-22 N/K (TL-22 DT/K) (both unladen weight, as stated by the source).
Which may carry more ballast and load?——No figureNo call on maximum permissible mass: no figure on record for the 5860 (DT) TL-22 N/K (TL-22 DT/K) and the 5211/5245.
Which has the wider choice of gears?12 to 24Traktorenlexikon, “Landini 5860”10Traktorenlexikon, “Zetor 5211”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?——No figureNo call on a creeper range: not stated for the 5860 (DT) TL-22 N/K (TL-22 DT/K) and the 5211/5245.
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “Landini 5860”25 km/h (15.5 mph)Traktorenlexikon, “Zetor 5211”AheadThe Landini 5860 (DT) TL-22 N/K (TL-22 DT/K) has 20% more top speed (5.0 km/h / 3.1 mph) than the ZETOR 5211/5245 (both top speed forward, as stated by the source).
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Landini 5860”540/1000 rpmTraktorenlexikon, “Zetor 5211”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?——No figureNo call on PTO independence: not stated for the 5860 (DT) TL-22 N/K (TL-22 DT/K) and the 5211/5245.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Landini 5860”Two-wheel or four-wheel driveTraktorenlexikon, “Zetor 5211”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1988–20001984–1993EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The ZETOR 5211/5245 has 56% more hydraulic flow (21.1 L/min / 5.6 gpm) than the Landini 5860 (DT) TL-22 N/K (TL-22 DT/K) (both pump flow, as stated by the source).
  • The Landini 5860 (DT) TL-22 N/K (TL-22 DT/K) has 17% more lift (290 kg / 639 lb) than the ZETOR 5211/5245 (both lift at the hitch ends, as stated by the source).
  • The ZETOR 5211/5245 is 27% heavier (600 kg / 1,323 lb) than the Landini 5860 (DT) TL-22 N/K (TL-22 DT/K) (both unladen weight, as stated by the source).
  • The Landini 5860 (DT) TL-22 N/K (TL-22 DT/K) has 20% more top speed (5.0 km/h / 3.1 mph) than the ZETOR 5211/5245 (both top speed forward, as stated by the source).
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the 5860 (DT) TL-22 N/K (TL-22 DT/K) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 5211/5245 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources