9 material differences · fewer than 12
Tractor oneKramer KWD 2501958–1959No measured PTO figureTractor twoSteyr 188 n1965–1966No measured PTO figure
Which should you choose?
Read our verdict on the KWD 250 and the 188 n → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | KWD 250 | 188 n | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 24 hp | 27.6 hp | +14% 188 n |
| Engine declared | Güldner 2 BS | Steyr WD-209 | differs |
| Displacement declared | 1.84 L | 1.99 L | +8% 188 n |
| Maximum torque declared | 72 lb·ft · 98 N·m | 87 lb·ft · 118 N·m | +20% 188 n |
| Transmission | |||
| Top speed declared | 12.3 mph · 19.8 km/h | 15.5 mph · 25 km/h | +26% 188 n |
| Clutch declared | Fichtel & Sachs double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 4.2 gpm · 16.0 L/min | — | — |
| Pressure declared | 1,707 psi · 118 bar | 2,134 psi · 147 bar | +25% 188 n |
| Rear PTO speeds declared | 528 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,417 lb · 1,550 kg | 3,300 lb · 1,497 kg | — |
| Maximum permissible mass declared | 3,968 lb · 1,800 kg | — | — |
| Wheelbase declared | 74.3 in · 1,887 mm | 72.6 in · 1,845 mm | — |
| Length declared | 116.1 in · 2,950 mm | 124.4 in · 3,160 mm | +7% 188 n |
| Width declared | 62.2 in · 1,580 mm | 61.3 in · 1,556 mm | — |
| Ground clearance declared | 15.0 in · 380 mm | 12.2 in · 310 mm | +23% KWD 250 |
| Turning radius, braked declared | — | 9.7 ft · 2.95 m | — |
| Fuel tank declared | 38.0 qt · 36 L | 42.3 qt · 40.0 L | +11% 188 n |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Kramer KWD 250 sources
- Source: Traktorenlexikon, “Kramer KWD 250”
- Source: Traktorenlexikon, “Güldner AB”
Steyr 188 n sources
- Source: Traktorenlexikon, “Steyr 188 n”
- Source: Traktorenlexikon, “Steyr 188”