11 material differences · fewer than 12
Tractor oneKramer 7141970–1973No measured PTO figureTractor twoSteyr 8075 (a)1983–1993No measured PTO figure
Which should you choose?
Read our verdict on the 714 and the 8075 (a) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 714 | 8075 (a) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 62.9 hp | 63.2 hp | — |
| Engine declared | Deutz F4L 912 | Steyr WD-411.45 or WD-411.46 | differs |
| Displacement declared | 3.77 L | 3.46 L | +9% 714 |
| Maximum torque declared | 146 lb·ft · 198 N·m | 169 lb·ft · 229 N·m | +16% 8075 (a) |
| Transmission | |||
| Top speed declared | 12.4–18.6 mph · 20–30 km/h | 15.5–24.9 mph · 25–40 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 8.5 gpm · 32.0 L/min | 10.7 gpm · 40.5 L/min | +27% 8075 (a) |
| Pressure declared | 2,489 psi · 172 bar | — | — |
| Rear PTO speeds declared | 540/1050 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,063–6,834 lb · 2,750–3,100 kg | 5,732 lb · 2,600 kg | differs |
| Wheelbase declared | 87.8 in · 2,230 mm | 83.4 in · 2,118 mm | +5% 714 |
| Length declared | 146.5 in · 3,720 mm | 139.8 in · 3,550 mm | — |
| Width declared | 75.6 in · 1,920 mm | 68.0 in · 1,726 mm | +11% 714 |
| Ground clearance declared | 13.8 in · 350 mm | 17.8 in · 453 mm | +29% 8075 (a) |
| Turning radius, braked declared | — | 10.9 ft · 3.32 m | — |
| Fuel tank declared | 67.6 qt · 64 L | 63.4 qt · 60.0 L | +7% 714 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Kramer 714 sources
- Source: Traktorenlexikon, “Kramer 714”
Steyr 8075 (a) sources
- Source: Traktorenlexikon, “Steyr 8075”