4 material differences · fewer than 12
Tractor oneJohn Deere 8295 Rfrom 2009No measured PTO figureTractor twoMassey Ferguson MF 84802004–2008No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (28%); the drive differs (Tracks; 4WD); they were not built in overlapping years (2009–2009; 2004–2008); the 8295 R is on tracks, not an alternative to an ordinary tractor. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
4 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 8295 R | MF 8480 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 291 hp | 286.2 hp | — |
| Engine declared | — | SISU-Power 84.329 ETA | — |
| Displacement declared | — | 8.42 L | — |
| Maximum torque declared | 966 lb·ft · 1,310 N·m | 798 lb·ft · 1,082 N·m | +21% 8295 R |
| Transmission | |||
| Top speed declared | 31.1 mph · 50 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Hydraulic control declared | Load sensing | Load sensing | — |
| Pump flow declared | — | 37.0 gpm · 140.2 L/min | — |
| Pressure declared | — | 2,176 psi · 150 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000/540E rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 27,448 lb · 12,450 kg | 21,440 lb · 9,725 kg | +28% 8295 R |
| Maximum permissible mass declared | — | 30,865 lb · 14,000 kg | — |
| Wheelbase declared | 118.9 in · 3,020 mm | 121.1 in · 3,075 mm | — |
| Length declared | 220.1 in · 5,590 mm | 209.4 in · 5,320 mm | — |
| Width declared | 97.6 in · 2,480 mm | 100.4 in · 2,550 mm | — |
| Ground clearance declared | — | 19.7 in · 500 mm | — |
| Fuel tank declared | 719.6 qt · 681 L | 697.4 qt · 660.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 8295 R sources
- Source: Traktorenlexikon, “John Deere 8295 R”
- Source: OECD test report 2616
Massey Ferguson MF 8480 sources
- Source: Traktorenlexikon, “Massey Ferguson MF 8480”
- Source: Traktorenlexikon, “Massey Ferguson MF 8470”