John Deere 8110 T or Steyr-Case 9220 a?
Which should you choose?
On performance, every comparable figure that differs favours the John Deere 8110 T: three-point lift and maximum permissible mass. On features, the Steyr-Case 9220 a is ahead on forward gears and PTO speeds.
- The Steyr-Case 9220 a suits PTO-driven implements (mowers, balers, pumps) better on this data: offers 540 rpm.
- The John Deere 8110 T suits loader and hydraulic implement work better on this data: 66% (1,976 kg / 4,357 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 8110 T | 9220 a | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 140.4 kW (188.3 hp)Traktorenlexikon, “John Deere 8110T” | 135.8 kW (182.1 hp)Traktorenlexikon, “Steyr 9220 a” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 8110 T and the 9220 a. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 8110 T and the 9220 a. |
| Which pumps more oil for implements? | 120.4 L/min (31.8 gpm)Traktorenlexikon, “John Deere 8110T” | 112.4 L/min (29.7 gpm)Traktorenlexikon, “Steyr 9220 a” | EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which lifts more on the three-point hitch? | 4,976 kg (10,971 lb)Traktorenlexikon, “John Deere 8110T” | 3,000 kg (6,614 lb)Traktorenlexikon, “Steyr 9220 a” | AheadThe John Deere 8110 T has 66% more lift (1,976 kg / 4,357 lb) than the Steyr-Case 9220 a (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 10,727 kg (23,649 lb)Traktorenlexikon, “John Deere 8110T” | 8,103 kg (17,864 lb)Traktorenlexikon, “Steyr 9220 a” | Ahead (a fact, not an advantage)The John Deere 8110 T is 32% heavier (2,624 kg / 5,785 lb) than the Steyr-Case 9220 a (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 14,288 kg (31,500 lb)Traktorenlexikon, “John Deere 8110T” | 11,575 kg (25,519 lb)Traktorenlexikon, “Steyr 9220 a” | AheadThe John Deere 8110 T has 23% higher maximum permissible mass (2,713 kg / 5,981 lb) than the Steyr-Case 9220 a (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 16Traktorenlexikon, “John Deere 8110T” | 24Traktorenlexikon, “Steyr 9220 a” | AheadThe Steyr-Case 9220 a has 50% more forward gears (8 gears) than the John Deere 8110 T (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | YesTraktorenlexikon, “Steyr 9220 a” | No figureNo call on a creeper range: not stated for the 8110 T. |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “John Deere 8110T” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Steyr 9220 a” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 1000 rpmTraktorenlexikon, “John Deere 8110T” | 540/1000 rpmTraktorenlexikon, “Steyr 9220 a” | AheadThe Steyr-Case 9220 a offers 540 rpm at the PTO, which the John Deere 8110 T does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “John Deere 8110T” | — | No figureNo call on PTO independence: not stated for the 9220 a. |
| Which drives on both axles? | TracksTraktorenlexikon, “John Deere 8110T” | 4WDTraktorenlexikon, “Steyr 9220 a” | DifferDrive differs: the John Deere 8110 T Tracks and the Steyr-Case 9220 a 4WD — tracks and wheels are different kinds of running gear, not called. |
| Which is newer, and what about parts? | 2000–2002 | 1997–1999 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The John Deere 8110 T has 66% more lift (1,976 kg / 4,357 lb) than the Steyr-Case 9220 a (both lift at the hitch ends, as stated by the source).
- The John Deere 8110 T is 32% heavier (2,624 kg / 5,785 lb) than the Steyr-Case 9220 a (both unladen weight, as stated by the source).
- The John Deere 8110 T has 23% higher maximum permissible mass (2,713 kg / 5,981 lb) than the Steyr-Case 9220 a (both maximum permissible mass, as stated by the source).
- The Steyr-Case 9220 a has 50% more forward gears (8 gears) than the John Deere 8110 T (both forward gears, as stated by the source).
- The Steyr-Case 9220 a offers 540 rpm at the PTO, which the John Deere 8110 T does not (as stated by the sources).
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Drive differs: the John Deere 8110 T Tracks and the Steyr-Case 9220 a 4WD — tracks and wheels are different kinds of running gear, not called.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources