10 material differences · fewer than 12
Tractor oneJohn Deere 7400 (A)1993–1997No measured PTO figureTractor twoMassey Ferguson MF 26801980–1985No measured PTO figure
Which should you choose?
Read our verdict on the 7400 (A) and the MF 2680 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 7400 (A) | MF 2680 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 118.4 hp | 118.4 hp | — |
| Engine declared | John Deere 6.068 TRW-02 | Perkins AT 6.354.4 | differs |
| Displacement declared | 6.79 L | 5.80 L | +17% 7400 (A) |
| Maximum torque declared | 350 lb·ft · 474 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 25.9 gpm · 98.0 L/min | 14.1 gpm · 53.3 L/min | +84% 7400 (A) |
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 12,663 lb · 5,744 kg | 11,883 lb · 5,390 kg | +7% 7400 (A) |
| Maximum permissible mass declared | 19,842 lb · 9,000 kg | 16,535 lb · 7,500 kg | +20% 7400 (A) |
| Wheelbase declared | 103.3 in · 2,625 mm | 107.3 in · 2,726 mm | — |
| Length declared | 174.6 in · 4,435 mm | 185.0 in · 4,700 mm | +6% MF 2680 |
| Width declared | 110.6–120.3 in · 2,808–3,056 mm | 90.6 in · 2,300 mm | differs |
| Ground clearance declared | 14.2 in · 360 mm | 18.9 in · 480 mm | +33% MF 2680 |
| Fuel tank declared | 215.6 qt · 204.0 L | 240.9 qt · 228.0 L | +12% MF 2680 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 7400 (A) sources
- Source: Traktorenlexikon, “John Deere 7400”
Massey Ferguson MF 2680 sources
- Source: Traktorenlexikon, “Massey Ferguson MF 2680”
- Source: Traktorenlexikon, “Massey Ferguson MF 1134”