1 material differences · fewer than 12
Tractor oneJohn Deere 7290Rfrom 2014No measured PTO figureTractor twoNew Holland T 80502007–2011No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2014–2014; 2007–2011). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
1 material differences · 8 fields identical or within 5%, which is not counted as material
| Field | 7290R | T 8050 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 308 hp | 321 hp | — |
| Engine declared | — | CUMMINS 6 TAA-9004 (TIER-III) | — |
| Displacement declared | — | 8.85 L | — |
| Maximum torque declared | 963 lb·ft · 1,305 N·m | 994 lb·ft · 1,348 N·m | — |
| Transmission | |||
| Top speed declared | 24.9–31.1 mph · 40–50 km/h | 24.9–31.1 mph · 40–50 km/h | — |
| Clutch declared | — | Electro-hydraulically operated wet multi-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 42.8 gpm · 162 L/min | 44.0 gpm · 166.6 L/min | — |
| Pressure declared | — | 3,336 psi · 230 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 23,845 lb · 10,816 kg | 24,268 lb · 11,008 kg | — |
| Maximum permissible mass declared | — | 30,865 lb · 14,000 kg | — |
| Wheelbase declared | 115.2 in · 2,925 mm | 121.2 in · 3,078 mm | — |
| Length declared | 207.8 in · 5,278 mm | 229.5 in · 5,829 mm | +10% T 8050 |
| Width declared | 100.2 in · 2,544 mm | 98.0 in · 2,490 mm | — |
| Ground clearance declared | — | 14.6 in · 372 mm | — |
| Fuel tank declared | — | 720.7 qt · 682.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 7290R sources
- Source: Traktorenlexikon, “John Deere 7290 R”
- Source: OECD test report 2851, 2014
- Source: OECD test report 2847, 2014
New Holland T 8050 sources
- Source: Traktorenlexikon, “New Holland T8050”