10 material differences · fewer than 12

Tractor oneJohn Deere 5300 (A)1992–1997No measured PTO figureTractor twoNew Holland TN 55 D/S (A)1999–2003No measured PTO figure

Which should you choose?

Read our verdict on the 5300 (A) and the TN 55 D/S (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

10 material differences · 6 fields identical or within 5%, which is not counted as material

John Deere 5300 (A) and New Holland TN 55 D/S (A), field by field
Field5300 (A)TN 55 D/S (A)Gap
Engine
Engine power, claimed claimed49.3 hp49.3 hp—
Engine declaredJohn Deere 3.029IVECO 8035.05 Bdiffers
Displacement declared2.94 L2.93 L—
Maximum torque declared133 lb·ft · 180 N·m136 lb·ft · 185 N·m—
Transmission
Top speed declared18.6 mph · 30 km/h18.6–24.9 mph · 30–40 km/hdiffers
Clutch declaredPedal-operated dry CARRARO single-disc clutch——
Hydraulics & hitch
Hydraulic centre declaredOpen centre——
Pump flow declared11.6 gpm · 43.9 L/min12.5 gpm · 47.4 L/min+8% TN 55 D/S (A)
Pressure declared3,408 psi · 235 bar2,466 psi · 170 bar+38% 5300 (A)
Three-point lift, at the coupling points declared3,803 lb · 1,725 kg5,886 lb · 2,670 kg+55% TN 55 D/S (A)
Rear PTO speeds declared540 rpm540/1000 rpmdiffers
Weight & dimensions
Unladen weight declared4,550 lb · 2,064 kg6,636 lb · 3,010 kg+46% TN 55 D/S (A)
Maximum permissible mass declared—8,818 lb · 4,000 kg—
Wheelbase declared80.7 in · 2,050 mm83.9 in · 2,130 mm—
Length declared139.4 in · 3,541 mm156.7 in · 3,980 mm+12% TN 55 D/S (A)
Width declared72.7–88.5 in · 1,846–2,249 mm70.6–90.7 in · 1,794–2,305 mm—
Ground clearance declared19.3 in · 490 mm13.0 in · 330 mm+48% 5300 (A)
Turning radius, braked declared9.8 ft · 3.00 m10.3 ft · 3.15 m—
Fuel tank declared72.0 qt · 68.1 L78.0 qt · 73.8 L+8% TN 55 D/S (A)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

John Deere 5300 (A) sources

Source
  • Source: Traktorenlexikon, “John Deere 5300 (USA)”
  • Source: Traktorenlexikon, “John Deere 5200 (USA)”

New Holland TN 55 D/S (A) sources

Source
  • Source: Traktorenlexikon, “New Holland TN55 D/S”