10 material differences · fewer than 12
Tractor oneJohn Deere 3050 (A)1986–1993No measured PTO figureTractor twoSOMECA 940 (TD)1978–1979No measured PTO figure
Which should you choose?
Read our verdict on the 3050 (A) and the 940 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 3050 (A) | 940 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 90.8 hp | 90.8 hp | — |
| Engine declared | John Deere 6.359 DL-008 | O.M.-FIAT CO 3/80 | differs |
| Displacement declared | 5.88 L | 4.94 L | +19% 3050 (A) |
| Maximum torque declared | 251 lb·ft · 340 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 15.5 mph · 25 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 13.8 gpm · 52.3 L/min | — | — |
| Pressure declared | 3,336 psi · 230 bar | 2,901 psi · 200 bar | +15% 3050 (A) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,642 lb · 3,920 kg | 8,708 lb · 3,950 kg | — |
| Maximum permissible mass declared | 14,771 lb · 6,700 kg | — | — |
| Wheelbase declared | 100.4 in · 2,551 mm | 93.3 in · 2,370 mm | +8% 3050 (A) |
| Length declared | 188.5 in · 4,787 mm | 159.4 in · 4,050 mm | +18% 3050 (A) |
| Width declared | 83.8 in · 2,129 mm | 76.2–99.7 in · 1,935–2,532 mm | differs |
| Ground clearance declared | 25.6 in · 650 mm | 22.4 in · 570 mm | +14% 3050 (A) |
| Turning radius, braked declared | — | 12.6 ft · 3.84 m | — |
| Fuel tank declared | 127.9–182.8 qt · 121.0–173.0 L | 95.1 qt · 90.0 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 3050 (A) sources
- Source: Traktorenlexikon, “John Deere 3050”
SOMECA 940 (TD) sources
- Source: Traktorenlexikon, “Someca 940”