6 material differences · fewer than 12
Tractor oneJohn Deere 2140 (A)1979–1986No measured PTO figureTractor twoVALMET 802/802-41980–1983No measured PTO figure
Which should you choose?
Read our verdict on the 2140 (A) and the 802/802-4 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 2140 (A) | 802/802-4 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 81.0 hp | 80.9 hp | — |
| Engine declared | — | VALMET 411 CS | — |
| Displacement declared | — | 4.40 L | — |
| Maximum torque declared | 199 lb·ft · 270 N·m | 226 lb·ft · 306 N·m | +13% 802/802-4 |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | — | Dry Fichtel & Sachs double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 12.4 gpm · 47.0 L/min | 11.4 gpm · 43.0 L/min | +9% 2140 (A) |
| Pressure declared | 2,466 psi · 170 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 6,724 lb · 3,050 kg | 7,802 lb · 3,539 kg | +16% 802/802-4 |
| Maximum permissible mass declared | 11,905 lb · 5,400 kg | — | — |
| Wheelbase declared | 89.8 in · 2,280 mm | 92.1 in · 2,339 mm | — |
| Length declared | 147.0 in · 3,735 mm | 151.2 in · 3,840 mm | — |
| Width declared | 80.9 in · 2,055 mm | 77.6 in · 1,971 mm | — |
| Ground clearance declared | 25.8 in · 656 mm | 18.9 in · 480 mm | +37% 2140 (A) |
| Turning radius, braked declared | — | 11.8 ft · 3.61 m | — |
| Fuel tank declared | 107.8 qt · 102.0 L | 95.1 qt · 90.0 L | +13% 2140 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 2140 (A) sources
- Source: Traktorenlexikon, “John Deere 2140”
VALMET 802/802-4 sources
- Source: Traktorenlexikon, “Valmet 802”