12 material differences
Tractor oneJohn Deere 21301972–1979No measured PTO figureTractor twoRenault 751-41973–1980No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
12 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 2130 | 751-4 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74.0 hp | 74.0 hp | — |
| Engine declared | John Deere 4.329 DL-01 | MWM D 226-4 | differs |
| Displacement declared | 3.92 L | 4.15 L | +6% 751-4 |
| Maximum torque declared | 188 lb·ft · 255 N·m | 188 lb·ft · 255 N·m | — |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | — | Dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 12.6 gpm · 47.6 L/min | 8.7 gpm · 33.0 L/min | +44% 2130 |
| Pressure declared | 3,989 psi · 275 bar | 2,321 psi · 160 bar | +72% 2130 |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,636 lb · 3,010 kg | 7,529 lb · 3,415 kg | +13% 751-4 |
| Maximum permissible mass declared | 9,921 lb · 4,500 kg | — | — |
| Wheelbase declared | 85.7 in · 2,178 mm | 95.7 in · 2,430 mm | +12% 751-4 |
| Length declared | 141.7 in · 3,598 mm | 162.6 in · 4,130 mm | +15% 751-4 |
| Width declared | 80.3–93.7 in · 2,040–2,380 mm | 76.4–97.6 in · 1,940–2,480 mm | — |
| Ground clearance declared | 25.8 in · 655 mm | 15.4 in · 390 mm | +68% 2130 |
| Turning radius, braked declared | 10.3 ft · 3.15 m | 16.6 ft · 5.05 m | +60% 751-4 |
| Fuel tank declared | 95.1 qt · 90.0 L | 86.6 qt · 82.0 L | +10% 2130 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 2130 sources
- Source: Traktorenlexikon, “John Deere 2130”
Renault 751-4 sources
- Source: Traktorenlexikon, “Renault 751-4 R7624”
- Source: Traktorenlexikon, “Fendt Farmer 108 S/SA”
- Source: Traktorenlexikon, “Renault 751-4S R7504”