8 material differences · fewer than 12
Tractor oneJohn Deere 2020 (A)1967–1972No measured PTO figureTractor twoSOMECA 715 (DT)1966–1967No measured PTO figure
Which should you choose?
Read our verdict on the 2020 (A) and the 715 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 2020 (A) | 715 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 59.3 hp | 59.3 hp | — |
| Engine declared | John Deere M 5 BL 4 or 4202 DL-01 | O.M.-FIAT CO-2 D/70 | differs |
| Displacement declared | 3.32 L | — | — |
| Maximum torque declared | — | 192 lb·ft · 260 N·m | — |
| Transmission | |||
| Top speed declared | 12.4–18.6 mph · 20–30 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | — | Pedal-operated two-stage dry FERODO double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | — | 7.0 gpm · 26.5 L/min | — |
| Pressure declared | — | 2,843 psi · 196 bar | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,379 lb · 2,440 kg | 6,349 lb · 2,880 kg | +18% 715 (DT) |
| Maximum permissible mass declared | 8,818 lb · 4,000 kg | — | — |
| Wheelbase declared | 85.8 in · 2,180 mm | 86.6 in · 2,200 mm | — |
| Length declared | 140.6 in · 3,570 mm | 149.6 in · 3,800 mm | +6% 715 (DT) |
| Width declared | 72.4 in · 1,840 mm | 70.9 in · 1,800 mm | — |
| Ground clearance declared | 13.8 in · 350 mm | 18.3 in · 465 mm | +33% 715 (DT) |
| Turning radius, braked declared | 10.7 ft · 3.26 m | 12.5 ft · 3.80 m | +17% 715 (DT) |
| Fuel tank declared | 78.0 qt · 73.8 L | 88.8 qt · 84.0 L | +14% 715 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 2020 (A) sources
- Source: Traktorenlexikon, “John Deere 2020”
SOMECA 715 (DT) sources
- Source: Traktorenlexikon, “Someca 715”
- Source: Traktorenlexikon, “Fiat 715/715 DT”