10 material differences · fewer than 12
Tractor oneJohn Deere 1950 (A)1987–1994No measured PTO figureTractor twoMassey Ferguson MF 373 (A)1987–1994No measured PTO figure
Which should you choose?
Read our verdict on the 1950 (A) and the MF 373 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 1950 (A) | MF 373 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 61.2 hp | 61.2 hp | — |
| Engine declared | John Deere 3.179 TL-001 | Perkins LD 4.236 | differs |
| Displacement declared | 2.94 L | 3.87 L | +32% MF 373 (A) |
| Maximum torque declared | 185 lb·ft · 251 N·m | 176 lb·ft · 239 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Pedal operated dry Fichtel & Sachs single disc clutch as driving clutch | Dry and air-cooled double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | Open centre | differs |
| Pump flow declared | 13.3 gpm · 50.2 L/min | — | — |
| Pressure declared | 3,336 psi · 230 bar | — | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,151 lb · 2,790 kg | 5,490 lb · 2,490 kg | +12% 1950 (A) |
| Maximum permissible mass declared | 9,259 lb · 4,200 kg | — | — |
| Wheelbase declared | 84.7 in · 2,151 mm | 88.5 in · 2,249 mm | — |
| Length declared | 148.2 in · 3,764 mm | 143.7 in · 3,650 mm | — |
| Width declared | 73.0 in · 1,854 mm | 75.8 in · 1,925 mm | — |
| Ground clearance declared | 24.4 in · 621 mm | 19.1 in · 485 mm | +28% 1950 (A) |
| Turning radius, braked declared | 10.8 ft · 3.29 m | 12.6 ft · 3.83 m | +16% MF 373 (A) |
| Fuel tank declared | 76.1 qt · 72.0 L | 90.9 qt · 86.0 L | +19% MF 373 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 1950 (A) sources
- Source: Traktorenlexikon, “John Deere 1950”
Massey Ferguson MF 373 (A) sources
- Source: Traktorenlexikon, “Massey Ferguson MF 373”