9 material differences · fewer than 12
Tractor oneJ.I. Case 10311966–1969No measured PTO figureTractor twoSOMECA 980 (TD)1979–1983No measured PTO figure
Which should you choose?
Read our verdict on the 1031 and the 980 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | 1031 | 980 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 102.1 hp | 96.7 hp | +6% 1031 |
| Engine declared | — | FIAT-IVECO 8065.02.217 | — |
| Displacement declared | — | 5.18 L | — |
| Maximum torque declared | — | 237 lb·ft · 321 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | — | dry Ferodo or Luk double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 12.0 gpm · 45.4 L/min | 8.4 gpm · 31.8 L/min | +43% 1031 |
| Pressure declared | — | 3,263 psi · 225 bar | — |
| Rear PTO speeds declared | 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 9,334 lb · 4,234 kg | 8,320 lb · 3,774 kg | +12% 1031 |
| Wheelbase declared | 108.9 in · 2,767 mm | 101.2 in · 2,570 mm | +8% 1031 |
| Length declared | 165.0 in · 4,191 mm | 152.2 in · 3,865 mm | +8% 1031 |
| Width declared | 88.0 in · 2,235 mm | 76.0–103.5 in · 1,930–2,630 mm | differs |
| Ground clearance declared | 16.0 in · 406 mm | 22.0 in · 560 mm | +38% 980 (TD) |
| Turning radius, braked declared | 11.2 ft · 3.43 m | 12.6 ft · 3.83 m | +12% 980 (TD) |
| Fuel tank declared | 192.0 qt · 181.7 L | 161.7 qt · 153.0 L | +19% 1031 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
J.I. Case 1031 sources
- Source: Traktorenlexikon, “Case 1031”
SOMECA 980 (TD) sources
- Source: Traktorenlexikon, “Someca 980”
- Source: Traktorenlexikon, “Fiat 980 DT”