11 material differences · fewer than 12
Tractor oneInternational Harvester 7431980–1989No measured PTO figureTractor twoMassey Ferguson MF 1751965–1968No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 2WD); they were not built in overlapping years (1980–1989; 1965–1968). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 743 | MF 175 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 66 hp | 65.2 hp | — |
| Engine declared | IH D-239 | Perkins A 4.236 | differs |
| Displacement declared | 3.91 L | 3.87 L | — |
| Maximum torque declared | 166 lb·ft · 225 N·m | 186 lb·ft · 252 N·m | +12% MF 175 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% 743 |
| Clutch declared | Dry dual clutch | Foot operated dry double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 7.9 gpm · 30.0 L/min | 6.3 gpm · 23.9 L/min | +26% 743 |
| Pressure declared | — | 3,001 psi · 207 bar | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,349 lb · 2,880 kg | 5,501 lb · 2,495 kg | +15% 743 |
| Maximum permissible mass declared | 12,125 lb · 5,500 kg | — | — |
| Wheelbase declared | 86.2–87.6 in · 2,190–2,226 mm | 84.0 in · 2,134 mm | — |
| Length declared | 148.4 in · 3,770 mm | 136.6 in · 3,470 mm | +9% 743 |
| Width declared | 80.3 in · 2,040 mm | 72.4 in · 1,840 mm | +11% 743 |
| Ground clearance declared | 18.0 in · 457 mm | 13.4 in · 340 mm | +34% 743 |
| Turning radius, braked declared | 12.1 ft · 3.70 m | 11.7 ft · 3.57 m | — |
| Fuel tank declared | 78.2 qt · 74 L | 86.6 qt · 82.0 L | +11% MF 175 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester 743 sources
- Source: Traktorenlexikon, “IHC 743”
Massey Ferguson MF 175 sources
- Source: Traktorenlexikon, “Massey Ferguson MF 175”
- Source: Traktorenlexikon, “Massey Ferguson MF 168 & MF 168A”
- Source: Traktorenlexikon, “Massey Ferguson MF 175 S”