11 material differences · fewer than 12
Tractor oneInternational Harvester 4741973–1974No measured PTO figureTractor twoUTB Universal 600from 1974No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 474 | Universal 600 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 57.3 hp | 57.3 hp | — |
| Engine declared | INTERNATIONAL-HARVESTER D-206 | UTB D-121 A | differs |
| Displacement declared | 3.38 L | 3.12 L | +8% 474 |
| Maximum torque declared | 156 lb·ft · 212 N·m | 134 lb·ft · 182 N·m | +16% 474 |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | Pedal-operated dry LAYCOCK single-disc clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 11.4–12.6 gpm · 43.1–47.7 L/min | 5.8 gpm · 21.8 L/min | differs |
| Pressure declared | — | 1,856 psi · 128 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,584 lb · 2,533 kg | 4,519 lb · 2,050 kg | +24% 474 |
| Wheelbase declared | 84.5 in · 2,146 mm | 81.1 in · 2,060 mm | — |
| Length declared | 135.0 in · 3,430 mm | 135.0 in · 3,430 mm | — |
| Width declared | 64.2 in · 1,630 mm | 59.8–89.4 in · 1,520–2,270 mm | differs |
| Ground clearance declared | 16.0 in · 406 mm | 18.5 in · 470 mm | +16% Universal 600 |
| Turning radius, braked declared | 9.0 ft · 2.74 m | 11.2 ft · 3.40 m | +24% Universal 600 |
| Fuel tank declared | 81.2 qt · 76.8 L | 57.1 qt · 54.0 L | +42% 474 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester 474 sources
- Source: Traktorenlexikon, “IHC 474”
- Source: Traktorenlexikon, “McCormick 624 (A)”
- Source: Traktorenlexikon, “IHC 474 (USA)”
UTB Universal 600 sources
- Source: Traktorenlexikon, “UTB U 600”