8 material differences · fewer than 12
Tractor oneInternational Harvester 4741973–1974No measured PTO figureTractor twoSteyr 8070 (a)1979–1992No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1973–1974; 1979–1992). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 474 | 8070 (a) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 57.3 hp | 57.3 hp | — |
| Engine declared | INTERNATIONAL-HARVESTER D-206 | Steyr WD-411.42 or WD-411.41 | differs |
| Displacement declared | 3.38 L | 3.46 L | — |
| Maximum torque declared | 156 lb·ft · 212 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 15.5–24.9 mph · 25–40 km/h | differs |
| Clutch declared | Pedal-operated dry LAYCOCK single-disc clutch | Dry Fichtel & Sachs double clutch or LuK double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 11.4–12.6 gpm · 43.1–47.7 L/min | — | — |
| Pressure declared | — | 3,553 psi · 245 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,584 lb · 2,533 kg | 5,703 lb · 2,587 kg | — |
| Maximum permissible mass declared | — | 8,818 lb · 4,000 kg | — |
| Wheelbase declared | 84.5 in · 2,146 mm | 84.8 in · 2,155 mm | — |
| Length declared | 135.0 in · 3,430 mm | 146.3 in · 3,716 mm | +8% 8070 (a) |
| Width declared | 64.2 in · 1,630 mm | 67.3–90.2 in · 1,710–2,290 mm | differs |
| Ground clearance declared | 16.0 in · 406 mm | 14.8 in · 375 mm | +8% 474 |
| Turning radius, braked declared | 9.0 ft · 2.74 m | 11.4 ft · 3.48 m | +27% 8070 (a) |
| Fuel tank declared | 81.2 qt · 76.8 L | 101.4 qt · 96.0 L | +25% 8070 (a) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester 474 sources
- Source: Traktorenlexikon, “IHC 474”
- Source: Traktorenlexikon, “McCormick 624 (A)”
- Source: Traktorenlexikon, “IHC 474 (USA)”
Steyr 8070 (a) sources
- Source: Traktorenlexikon, “Steyr 8070”