14 material differences

Tractor oneInternational Harvester 1055 XL1981–1982No measured PTO figureTractor twoSAME Antares 1001989–1995No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (29%); the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1981–1982; 1989–1995). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

14 material differences · 1 fields identical or within 5%, which is not counted as material

International Harvester 1055 XL and SAME Antares 100, field by field
Field1055 XLAntares 100Gap
Engine
Engine power, claimed claimed98.6 hp98.6 hp—
Engine declaredIH D-358SAME 1000.4 ATIdiffers
Displacement declared5.87 L4.00 L+47% 1055 XL
Maximum torque declared279 lb·ft · 378 N·m258 lb·ft · 350 N·m+8% 1055 XL
Transmission
Top speed declared15.5–18.6 mph · 25–30 km/h24.9 mph · 40 km/hdiffers
Clutch declared—Pedal-operated dry S.L.H. single-disc clutch—
Hydraulics & hitch
Hydraulic centre declaredOpen centre——
Pump flow declared9.5 gpm · 36.0 L/min11.2 gpm · 42.5 L/min+18% Antares 100
Pressure declared2,466 psi · 170 bar2,176 psi · 150 bar+13% 1055 XL
Rear PTO speeds declared540/1000 rpm540/1000/540E/1000E rpmdiffers
Weight & dimensions
Unladen weight declared9,634 lb · 4,370 kg7,496 lb · 3,400 kg+29% 1055 XL
Maximum permissible mass declared—11,905 lb · 5,400 kg—
Wheelbase declared103.5 in · 2,630 mm91.3 in · 2,320 mm+13% 1055 XL
Length declared165.1 in · 4,194 mm152.0 in · 3,860 mm+9% 1055 XL
Width declared90.8 in · 2,306 mm74.8–102.4 in · 1,900–2,600 mmdiffers
Ground clearance declared20.2 in · 512 mm18.5 in · 470 mm+9% 1055 XL
Turning radius, braked declared14.4 ft · 4.40 m9.6 ft · 2.94 m+50% 1055 XL
Fuel tank declared147.9 qt · 140 L116.2 qt · 110.0 L+27% 1055 XL

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

International Harvester 1055 XL sources

Source
  • Source: Traktorenlexikon, “IHC 1055 XL”

SAME Antares 100 sources

Source
  • Source: Traktorenlexikon, “SAME Antares 100”