8 material differences · fewer than 12
Tractor oneInternational Harvester Farmall 10661971–1976No measured PTO figureTractor twoMassey Ferguson MF 11141978–1990No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1971–1976; 1978–1990). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Farmall 1066 | MF 1114 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 115.5 hp | 109 hp | +6% Farmall 1066 |
| Engine declared | INTERNATIONAL HARVESTER DT-414 | Perkins A 6.354-4 | differs |
| Displacement declared | 6.78 L | 5.80 L | +17% Farmall 1066 |
| Maximum torque declared | — | 273 lb·ft · 370 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% Farmall 1066 |
| Clutch declared | — | Pedal-operated dry Luk double clutch with 330 mm diameter | — |
| Hydraulics & hitch | |||
| Pump flow declared | 12.0 gpm · 45.5 L/min | — | — |
| Pressure declared | — | 2,418 psi · 166.7 bar | — |
| Three-point lift, at the coupling points declared | 5,798 lb · 2,630 kg | 8,598 lb · 3,900 kg | +48% MF 1114 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 12,145 lb · 5,509 kg | 10,692 lb · 4,850 kg | +14% Farmall 1066 |
| Wheelbase declared | 104.8 in · 2,662 mm | 111.8 in · 2,840 mm | +7% MF 1114 |
| Length declared | 165.0 in · 4,191 mm | 185.0 in · 4,700 mm | +12% MF 1114 |
| Width declared | 98.0 in · 2,489 mm | 98.4 in · 2,500 mm | — |
| Ground clearance declared | 16.0 in · 406 mm | — | — |
| Turning radius, braked declared | 12.0 ft · 3.66 m | — | — |
| Fuel tank declared | 168.0 qt · 159.0 L | 190.2 qt · 180.0 L | +13% MF 1114 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester Farmall 1066 sources
- Source: Traktorenlexikon, “IHC 1066”
- Source: Traktorenlexikon, “Farmall Farmall 1066”
Massey Ferguson MF 1114 sources
- Source: Traktorenlexikon, “Massey Ferguson MF 1114”
- Source: Traktorenlexikon, “Massey Ferguson MF 399”