International Harvester D-324 Standard or SOMECA 250 (DT)?
Which should you choose?
On performance, no comparable figure differs by more than its threshold: on this data the machines are level. On features, the SOMECA 250 (DT) is ahead on top speed and drive.
- The SOMECA 250 (DT) suits road haulage better on this data: 32% (6.0 km/h / 3.7 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | D-324 Standard | 250 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 16.8 kW (22.6 hp)Traktorenlexikon, “McCormick D-324 Standard” | 16.8 kW (22.6 hp)Traktorenlexikon, “Someca 250” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the D-324 Standard and the 250 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the D-324 Standard and the 250 (DT). |
| Which pumps more oil for implements? | — | 9.3 L/min (2.5 gpm)Traktorenlexikon, “Someca 250” | No figureNo call on hydraulic flow: no figure on record for the D-324 Standard. |
| Which lifts more on the three-point hitch? | 600 kg (1,323 lb)Traktorenlexikon, “McCormick D-324 Standard” | 600 kg (1,323 lb)Traktorenlexikon, “Someca 250” | EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which is heavier, for traction? | 1,536 kg (3,386 lb)Traktorenlexikon, “McCormick D-324 Standard” | 1,070 kg (2,359 lb)Traktorenlexikon, “Someca 250” | Ahead (a fact, not an advantage)The International Harvester D-324 Standard is 44% heavier (466 kg / 1,027 lb) than the SOMECA 250 (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the D-324 Standard and the 250 (DT). |
| Which has the wider choice of gears? | 6 to 8Traktorenlexikon, “McCormick D-324 Standard” | 6Traktorenlexikon, “Someca 250” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | YesTraktorenlexikon, “McCormick D-324 Standard” | — | No figureNo call on a creeper range: not stated for the 250 (DT). |
| Which is faster on the road? | 19 km/h (11.8 mph)Traktorenlexikon, “McCormick D-324 Standard” | 25 km/h (15.5 mph)Traktorenlexikon, “Someca 250” | AheadThe SOMECA 250 (DT) has 32% more top speed (6.0 km/h / 3.7 mph) than the International Harvester D-324 Standard (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “McCormick D-324 Standard” | 540 rpmTraktorenlexikon, “Someca 250” | EvenEven on PTO speeds: the same speeds (540 rpm). |
| Which PTO runs independently of the ground drive? | dependent (stops with the clutch)Traktorenlexikon, “McCormick D-324 Standard” | dependent (stops with the clutch)Traktorenlexikon, “Someca 250” | EvenEven on PTO independence: every PTO is dependent. |
| Which drives on both axles? | 2WDTraktorenlexikon, “McCormick D-324 Standard” | Two-wheel or four-wheel driveTraktorenlexikon, “Someca 250” | AheadThe SOMECA 250 (DT) is available with four-wheel drive; the International Harvester D-324 Standard is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1958–1962 | 1968–1971 | Ahead (a fact, not an advantage)The SOMECA 250 (DT) is newer: production began 10 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The International Harvester D-324 Standard is 44% heavier (466 kg / 1,027 lb) than the SOMECA 250 (DT) (both unladen weight, as stated by the source).
- The SOMECA 250 (DT) has 32% more top speed (6.0 km/h / 3.7 mph) than the International Harvester D-324 Standard (both top speed forward, as stated by the source).
- The SOMECA 250 (DT) is available with four-wheel drive; the International Harvester D-324 Standard is two-wheel drive (as stated by the sources).
- The SOMECA 250 (DT) is newer: production began 10 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540 rpm).
- Even on PTO independence: every PTO is dependent.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources