International Harvester D-219 or International Harvester 184?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the D-219 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 184 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The International Harvester D-219 suits loader and hydraulic implement work better on this data: 157% (11.9 L/min / 3.1 gpm) more hydraulic flow.
- The International Harvester D-219 suits road haulage better on this data: 50% (6.0 km/h / 3.7 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | D-219 | 184 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 14 kW (19 hp)Traktorenlexikon, “McCormick D-219” | 13.2 kW (17.7 hp)Traktorenlexikon, “IHC International 184” | Not comparableNot comparable on power at the PTO shaft: the D-219 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 184 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the D-219 and the 184. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the D-219 and the 184. |
| Which pumps more oil for implements? | 19.5 L/min (5.2 gpm)Traktorenlexikon, “McCormick D-219” | 7.6 L/min (2.0 gpm)Traktorenlexikon, “IHC International 184” | AheadThe International Harvester D-219 has 157% more hydraulic flow (11.9 L/min / 3.1 gpm) than the International Harvester 184 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 300 kg (661 lb)Traktorenlexikon, “McCormick D-219” | — | No figureNo call on three-point lift: no figure on record for the 184. |
| Which is heavier, for traction? | 1,271 kg (2,802 lb)Traktorenlexikon, “McCormick D-219” | 734 kg (1,618 lb)Traktorenlexikon, “IHC International 184” | Ahead (a fact, not an advantage)The International Harvester D-219 is 73% heavier (537 kg / 1,184 lb) than the International Harvester 184 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 1,950 kg (4,299 lb)Traktorenlexikon, “McCormick D-219” | — | No figureNo call on maximum permissible mass: no figure on record for the 184. |
| Which has the wider choice of gears? | 6Traktorenlexikon, “McCormick D-219” | 3 to 6Traktorenlexikon, “IHC International 184” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | YesTraktorenlexikon, “McCormick D-219” | — | No figureNo call on a creeper range: not stated for the 184. |
| Which is faster on the road? | 18 km/h (11.2 mph)Traktorenlexikon, “McCormick D-219” | 12 km/h (7.5 mph)Traktorenlexikon, “IHC International 184” | AheadThe International Harvester D-219 has 50% more top speed (6.0 km/h / 3.7 mph) than the International Harvester 184 (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “McCormick D-219” | 1800 rpmTraktorenlexikon, “IHC International 184” | No figureNo call on PTO speeds: no standard PTO speed stated for the 184. |
| Which PTO runs independently of the ground drive? | dependent (stops with the clutch)Traktorenlexikon, “McCormick D-219” | — | No figureNo call on PTO independence: not stated for the 184. |
| Which drives on both axles? | 2WDTraktorenlexikon, “McCormick D-219” | 2WDTraktorenlexikon, “IHC International 184” | EvenEven on drive: all two-wheel drive. |
| Which is newer, and what about parts? | 1962–1966 | 1977–1980 | Ahead (a fact, not an advantage)The International Harvester 184 is newer: production began 15 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The International Harvester D-219 has 157% more hydraulic flow (11.9 L/min / 3.1 gpm) than the International Harvester 184 (both pump flow, as stated by the source).
- The International Harvester D-219 is 73% heavier (537 kg / 1,184 lb) than the International Harvester 184 (both unladen weight, as stated by the source).
- The International Harvester D-219 has 50% more top speed (6.0 km/h / 3.7 mph) than the International Harvester 184 (both top speed forward, as stated by the source).
- The International Harvester 184 is newer: production began 15 years later. We hold no parts-availability data, so there is no call on parts.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on drive: all two-wheel drive.
- Not comparable on power at the PTO shaft: the D-219 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 184 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass, a creeper range, PTO speeds and PTO independence.
← Every figure for both machines, side by side, with sources