International Harvester D-219 or International Harvester F-137 D?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the D-219 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the F-137 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The International Harvester D-219 suits loader and hydraulic implement work better on this data: 63% (7.5 L/min / 2.0 gpm) more hydraulic flow.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for International Harvester D-219 and International Harvester F-137 D, with the call on each
QuestionD-219F-137 DCall
Which puts more power through the PTO shaft?14 kW (19 hp)Traktorenlexikon, “McCormick D-219”14.7 kW (19.7 hp)Traktorenlexikon, “McCormick F-137 D”Not comparableNot comparable on power at the PTO shaft: the D-219 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the F-137 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the D-219 and the F-137 D.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the D-219 and the F-137 D.
Which pumps more oil for implements?19.5 L/min (5.2 gpm)Traktorenlexikon, “McCormick D-219”12.0 L/min (3.2 gpm)Traktorenlexikon, “McCormick F-137 D”AheadThe International Harvester D-219 has 63% more hydraulic flow (7.5 L/min / 2.0 gpm) than the International Harvester F-137 D (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?300 kg (661 lb)Traktorenlexikon, “McCormick D-219”No figureNo call on three-point lift: no figure on record for the F-137 D.
Which is heavier, for traction?1,271 kg (2,802 lb)Traktorenlexikon, “McCormick D-219”1,080 kg (2,381 lb)Traktorenlexikon, “McCormick F-137 D”Ahead (a fact, not an advantage)The International Harvester D-219 is 18% heavier (191 kg / 421 lb) than the International Harvester F-137 D (both unladen weight, as stated by the source).
Which may carry more ballast and load?1,950 kg (4,299 lb)Traktorenlexikon, “McCormick D-219”No figureNo call on maximum permissible mass: no figure on record for the F-137 D.
Which has the wider choice of gears?6Traktorenlexikon, “McCormick D-219”6Traktorenlexikon, “McCormick F-137 D”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?YesTraktorenlexikon, “McCormick D-219”YesTraktorenlexikon, “McCormick F-137 D”EvenEven on a creeper range: every machine offers one.
Which is faster on the road?18 km/h (11.2 mph)Traktorenlexikon, “McCormick D-219”18 km/h (11.2 mph)Traktorenlexikon, “McCormick F-137 D”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “McCormick D-219”542 rpmTraktorenlexikon, “McCormick F-137 D”No figureNo call on PTO speeds: no standard PTO speed stated for the F-137 D.
Which PTO runs independently of the ground drive?dependent (stops with the clutch)Traktorenlexikon, “McCormick D-219”dependent (stops with the clutch)Traktorenlexikon, “McCormick F-137 D”EvenEven on PTO independence: every PTO is dependent.
Which drives on both axles?2WDTraktorenlexikon, “McCormick D-219”2WDTraktorenlexikon, “McCormick F-137 D”EvenEven on drive: all two-wheel drive.
Which is newer, and what about parts?1962–19661960–1964EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The International Harvester D-219 has 63% more hydraulic flow (7.5 L/min / 2.0 gpm) than the International Harvester F-137 D (both pump flow, as stated by the source).
  • The International Harvester D-219 is 18% heavier (191 kg / 421 lb) than the International Harvester F-137 D (both unladen weight, as stated by the source).
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on a creeper range: every machine offers one.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO independence: every PTO is dependent.
  • Even on drive: all two-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the D-219 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the F-137 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass and PTO speeds.

← Every figure for both machines, side by side, with sources