International Harvester D-217 Standard or Renault N 73?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the D-217 Standard has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the N 73 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Renault N 73 suits road haulage better on this data: 11% (2.0 km/h / 1.2 mph) more top speed.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “similar machines”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for International Harvester D-217 Standard and Renault N 73, with the call on each
QuestionD-217 StandardN 73Call
Which puts more power through the PTO shaft?12.5 kW (16.8 hp)Traktorenlexikon, “McCormick D-217 Standard”11.8 kW (15.8 hp)Traktorenlexikon, “Renault N73 Junior R7053”Not comparableNot comparable on power at the PTO shaft: the D-217 Standard has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the N 73 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the D-217 Standard and the N 73.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the D-217 Standard and the N 73.
Which pumps more oil for implements?19.0 L/min (5.0 gpm)Traktorenlexikon, “McCormick D-217 Standard”6.0 L/min (1.6 gpm)Traktorenlexikon, “Renault N73 Junior R7053”AheadThe International Harvester D-217 Standard has 217% more hydraulic flow (13.0 L/min / 3.4 gpm) than the Renault N 73 (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?300 kg (661 lb)Traktorenlexikon, “McCormick D-217 Standard”1,200 kg (2,646 lb)Traktorenlexikon, “Renault N73 Junior R7053”AheadThe Renault N 73 has 300% more lift (900 kg / 1,984 lb) than the International Harvester D-217 Standard (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?1,185 kg (2,612 lb)Traktorenlexikon, “McCormick D-217 Standard”1,045 kg (2,304 lb)Traktorenlexikon, “Renault N73 Junior R7053”Ahead (a fact, not an advantage)The International Harvester D-217 Standard is 13% heavier (140 kg / 309 lb) than the Renault N 73 (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the D-217 Standard and the N 73.
Which has the wider choice of gears?6Traktorenlexikon, “McCormick D-217 Standard”6Traktorenlexikon, “Renault N73 Junior R7053”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?YesTraktorenlexikon, “McCormick D-217 Standard”No figureNo call on a creeper range: not stated for the N 73.
Which is faster on the road?18 km/h (11.2 mph)Traktorenlexikon, “McCormick D-217 Standard”20 km/h (12.4 mph)Traktorenlexikon, “Renault N73 Junior R7053”AheadThe Renault N 73 has 11% more top speed (2.0 km/h / 1.2 mph) than the International Harvester D-217 Standard (both top speed forward, as stated by the source).
Which offers more PTO speeds?540 rpmTraktorenlexikon, “McCormick D-217 Standard”540 rpmTraktorenlexikon, “Renault N73 Junior R7053”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?dependent (stops with the clutch)Traktorenlexikon, “McCormick D-217 Standard”dependent (stops with the clutch)Traktorenlexikon, “Renault N73 Junior R7053”EvenEven on PTO independence: every PTO is dependent.
Which drives on both axles?2WDTraktorenlexikon, “McCormick D-217 Standard”2WDTraktorenlexikon, “Renault N73 Junior R7053”EvenEven on drive: all two-wheel drive.
Which is newer, and what about parts?1956–19621960–1964EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The International Harvester D-217 Standard has 217% more hydraulic flow (13.0 L/min / 3.4 gpm) than the Renault N 73 (both pump flow, as stated by the source).
  • The Renault N 73 has 300% more lift (900 kg / 1,984 lb) than the International Harvester D-217 Standard (both lift at the hitch ends, as stated by the source).
  • The International Harvester D-217 Standard is 13% heavier (140 kg / 309 lb) than the Renault N 73 (both unladen weight, as stated by the source).
  • The Renault N 73 has 11% more top speed (2.0 km/h / 1.2 mph) than the International Harvester D-217 Standard (both top speed forward, as stated by the source).
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Even on PTO independence: every PTO is dependent.
  • Even on drive: all two-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the D-217 Standard has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the N 73 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources