8 material differences · fewer than 12
Tractor oneInternational Harvester D-2141958–1962No measured PTO figureTractor twoJ. Bautz AG B 14 AS1949–1951No measured PTO figure
Which should you choose?
Read our verdict on the D-214 and the B 14 AS → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | D-214 | B 14 AS | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 13.8 hp | 14.1 hp | — |
| Engine declared | INTERNATIONAL-HARVESTER DD-66 | Zanker M1 | differs |
| Displacement declared | 1.09 L | 1.02 L | +6% D-214 |
| Maximum torque declared | 38 lb·ft · 51 N·m | — | — |
| Transmission | |||
| Top speed declared | 11.8 mph · 19 km/h | 11.2 mph · 18 km/h | +6% D-214 |
| Clutch declared | Pedal-operated dry Fichtel & Sachs single-plate clutch | Single plate dry clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 5.0 gpm · 19.0 L/min | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 2,538 lb · 1,151 kg | 2,535 lb · 1,150 kg | — |
| Maximum permissible mass declared | 3,527 lb · 1,600 kg | 3,748 lb · 1,700 kg | +6% B 14 AS |
| Wheelbase declared | 68.1 in · 1,730 mm | 56.9 in · 1,445 mm | +20% D-214 |
| Length declared | 105.2 in · 2,672 mm | 92.9 in · 2,360 mm | +13% D-214 |
| Width declared | 62.2 in · 1,581 mm | 59.8 in · 1,520 mm | — |
| Ground clearance declared | 13.9 in · 352 mm | 11.8 in · 300 mm | +17% D-214 |
| Turning radius, braked declared | 8.0 ft · 2.45 m | — | — |
| Fuel tank declared | 28.5 qt · 27.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester D-214 sources
- Source: Traktorenlexikon, “McCormick D-214 Standard”
- Source: Traktorenlexikon, “McCormick DLD 2”
J. Bautz AG B 14 AS sources
- Source: Traktorenlexikon, “Bautz B 14 AS/AS 14”