International Harvester 824 (A) or Renault 75-12 LS?

Which should you choose?

On performance, no comparable figure differs by more than its threshold: on this data the machines are level. On features, the International Harvester 824 (A) is ahead on drive.

  • The International Harvester 824 (A) suits heavy draft work (ploughing, cultivating) better on this data: four-wheel drive.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for International Harvester 824 (A) and Renault 75-12 LS, with the call on each
Question824 (A)75-12 LSCall
Which puts more power through the PTO shaft?46.3 kW (62.1 hp)Traktorenlexikon, “McCormick 824 (A)”46.3 kW (62.1 hp)Traktorenlexikon, “Renault 75-12 LS R3141”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 824 (A) and the 75-12 LS.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 824 (A) and the 75-12 LS.
Which pumps more oil for implements?29.2 L/min (7.7 gpm)Traktorenlexikon, “McCormick 824 (A)”30.3 L/min (8.0 gpm)Traktorenlexikon, “Renault 75-12 LS R3141”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?3,825 kg (8,433 lb)Traktorenlexikon, “Renault 75-12 LS R3141”No figureNo call on three-point lift: no figure on record for the 824 (A).
Which is heavier, for traction?3,145 kg (6,934 lb)Traktorenlexikon, “McCormick 824 (A)”2,990 kg (6,592 lb)Traktorenlexikon, “Renault 75-12 LS R3141”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?5,650 kg (12,456 lb)Traktorenlexikon, “Renault 75-12 LS R3141”No figureNo call on maximum permissible mass: no figure on record for the 824 (A).
Which has the wider choice of gears?8 to 12Traktorenlexikon, “McCormick 824 (A)”12 to 24Traktorenlexikon, “Renault 75-12 LS R3141”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 824 (A) and the 75-12 LS.
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “McCormick 824 (A)”30 km/h (18.6 mph)Traktorenlexikon, “Renault 75-12 LS R3141”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “McCormick 824 (A)”540/1000 rpmTraktorenlexikon, “Renault 75-12 LS R3141”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “McCormick 824 (A)”independentTraktorenlexikon, “Renault 75-12 LS R3141”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?2WD / 4WDTraktorenlexikon, “McCormick 824 (A)”2WDTraktorenlexikon, “Renault 75-12 LS R3141”AheadThe International Harvester 824 (A) is available with four-wheel drive; the Renault 75-12 LS is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1971–19741985–1989Ahead (a fact, not an advantage)The Renault 75-12 LS is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The International Harvester 824 (A) is available with four-wheel drive; the Renault 75-12 LS is two-wheel drive (as stated by the sources).
  • The Renault 75-12 LS is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on PTO independence: every PTO is independent.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources