5 material differences · fewer than 12

Tractor oneInternational Harvester 10-20 Industrial1923–1940No measured PTO figureTractor twoLanz D 85391934–1939No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (67%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

5 material differences · 1 fields identical or within 5%, which is not counted as material

International Harvester 10-20 Industrial and Lanz D 8539, field by field
Field10-20 IndustrialD 8539Gap
Engine
Engine power, claimed claimed27.5 hp29.5 hp+7% D 8539
Engine declaredINTERNATIONAL HARVESTER 284——
Displacement declared4.65 L——
Transmission
Top speed declared5.0 mph · 8.0 km/h13.4 mph · 21.5 km/h+169% D 8539
Clutch declaredPedal-operated dry single-disc clutchpedal-operated three-jaw clutch with clutch brakediffers
Hydraulics & hitch
Rear PTO speeds declared742 rpm——
Weight & dimensions
Unladen weight declared5,481 lb · 2,486 kg9,149 lb · 4,150 kg+67% D 8539
Wheelbase declared78.0 in · 1,981 mm76.4–77.8 in · 1,940–1,975 mm—
Length declared118.0 in · 2,997 mm129.9 in · 3,300 mm+10% D 8539
Width declared59.0 in · 1,499 mm70.9 in · 1,800 mm+20% D 8539
Ground clearance declared—9.4–10.6 in · 240–270 mm—
Fuel tank declared—95.1–100.4 qt · 90–95 L—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

International Harvester 10-20 Industrial sources

Source
  • Source: Traktorenlexikon, “McCormick 10-20 Industrial”
  • Source: Traktorenlexikon, “McCormick 10-20”
  • Source: Traktorenlexikon, “IHC 10-20 Industrial”

Lanz D 8539 sources

Source
  • Source: Traktorenlexikon, “Lanz D 8539”