5 material differences · fewer than 12
Tractor oneHürlimann Prince 435 DT1995–1999No measured PTO figureTractor twoSAME 35 DT1992–2003No measured PTO figure
Which should you choose?
Read our verdict on the Prince 435 DT and the 35 DT → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 11 fields identical or within 5%, which is not counted as material
| Field | Prince 435 DT | 35 DT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34.6 hp | 34.5 hp | — |
| Engine declared | MITSUBISHI K4 F-D | MITSUBISHI K4 F-D | — |
| Displacement declared | 1.49 L | 1.49 L | — |
| Maximum torque declared | — | 63 lb·ft · 84.9 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% Prince 435 DT |
| Clutch declared | Pedal-operated dry SDF single-disc clutch | Pedal operated dry single-plate clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | Load sensing | — |
| Pump flow declared | 1.4 gpm · 5.3 L/min | 7.9 gpm · 30.0 L/min | +466% 35 DT |
| Pressure declared | 2,901 psi · 200 bar | 1,305 psi · 90 bar | +122% Prince 435 DT |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 2,601 lb · 1,180 kg | 2,513 lb · 1,140 kg | — |
| Maximum permissible mass declared | — | 5,291 lb · 2,400 kg | — |
| Wheelbase declared | 64.2 in · 1,630 mm | 64.2 in · 1,630 mm | — |
| Length declared | 116.5 in · 2,960 mm | 116.5 in · 2,960 mm | — |
| Width declared | 40.2–53.5 in · 1,020–1,360 mm | 48.8–52.8 in · 1,240–1,340 mm | differs |
| Ground clearance declared | 14.2 in · 360 mm | 13.6 in · 345 mm | — |
| Turning radius, braked declared | 9.0 ft · 2.73 m | 8.9 ft · 2.71 m | — |
| Fuel tank declared | 30.6 qt · 29.0 L | 30.6 qt · 29.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hürlimann Prince 435 DT sources
- Source: Traktorenlexikon, “Hürlimann Prince 435”
SAME 35 DT sources
- Source: Traktorenlexikon, “SAME Solaris 35”
- Source: Traktorenlexikon, “Hürlimann Prince 435”