8 material differences · fewer than 12
Tractor oneHürlimann H-345 (A)1982–1986No measured PTO figureTractor twoOLIVER 1255 (4 WD)1969–1971No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1982–1986; 1969–1971). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | H-345 (A) | 1255 (4 WD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47.3 hp | 41.4 hp | +14% H-345 (A) |
| Engine declared | SAME 983-L | FIAT 853-A | differs |
| Displacement declared | 2.72 L | 2.34 L | +16% H-345 (A) |
| Maximum torque declared | — | 105 lb·ft · 143 N·m | — |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | Dry double clutch | Pedal-operated dry LuK single-disc clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 9.0 gpm · 34.0 L/min | 5.8 gpm · 21.8 L/min | +56% H-345 (A) |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,453 lb · 2,020 kg | 4,123 lb · 1,870 kg | +8% H-345 (A) |
| Wheelbase declared | 76.6 in · 1,945 mm | 75.7 in · 1,922 mm | — |
| Length declared | 126.0 in · 3,200 mm | 115.0 in · 2,921 mm | +10% H-345 (A) |
| Width declared | 67.7 in · 1,720 mm | 62.9–87.3 in · 1,598–2,218 mm | differs |
| Ground clearance declared | 18.7 in · 475 mm | 18.2 in · 462 mm | — |
| Turning radius, braked declared | — | 9.4 ft · 2.86 m | — |
| Fuel tank declared | 57.1 qt · 54.0 L | 57.1 qt · 54.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hürlimann H-345 (A) sources
- Source: Traktorenlexikon, “Hürlimann H 345 (A)”
- Source: Traktorenlexikon, “Lamborghini 483 DT”
OLIVER 1255 (4 WD) sources
- Source: Traktorenlexikon, “Oliver 1255”
- Source: Traktorenlexikon, “Oliver 1250-A”