Hermann Lanz D 28 (TD) or URSUS C-328?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the D 28 (TD) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the C-328 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The URSUS C-328 suits road haulage better on this data: 15% (3.0 km/h / 1.9 mph) more top speed.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Hermann Lanz D 28 (TD) and URSUS C-328, with the call on each
QuestionD 28 (TD)C-328Call
Which puts more power through the PTO shaft?20.5 kW (27.5 hp)Traktorenlexikon, “HELA D 28 (TD)”20.6 kW (27.6 hp)Traktorenlexikon, “Ursus C-328”Not comparableNot comparable on power at the PTO shaft: the D 28 (TD) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the C-328 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the D 28 (TD) and the C-328.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the D 28 (TD) and the C-328.
Which pumps more oil for implements?18.0 L/min (4.8 gpm)Traktorenlexikon, “Ursus C-328”No figureNo call on hydraulic flow: no figure on record for the D 28 (TD).
Which lifts more on the three-point hitch?700 kg (1,543 lb)Traktorenlexikon, “Ursus C-328”No figureNo call on three-point lift: no figure on record for the D 28 (TD).
Which is heavier, for traction?1,750 kg (3,858 lb)Traktorenlexikon, “HELA D 28 (TD)”1,654 kg (3,646 lb)Traktorenlexikon, “Ursus C-328”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the D 28 (TD) and the C-328.
Which has the wider choice of gears?5Traktorenlexikon, “HELA D 28 (TD)”6Wikipedia (pl): Ursus C-328 (open data)EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the D 28 (TD) and the C-328.
Which is faster on the road?20 km/h (12.4 mph)Traktorenlexikon, “HELA D 28 (TD)”23 km/h (14.3 mph)Traktorenlexikon, “Ursus C-328”AheadThe URSUS C-328 has 15% more top speed (3.0 km/h / 1.9 mph) than the Hermann Lanz D 28 (TD) (both top speed forward, as stated by the source).
Which offers more PTO speeds?550 rpmTraktorenlexikon, “HELA D 28 (TD)”540 rpmTraktorenlexikon, “Ursus C-328”No figureNo call on PTO speeds: no standard PTO speed stated for the D 28 (TD).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Ursus C-328”No figureNo call on PTO independence: not stated for the D 28 (TD).
Which drives on both axles?2WDTraktorenlexikon, “HELA D 28 (TD)”2WDTraktorenlexikon, “Ursus C-328”EvenEven on drive: all two-wheel drive.
Which is newer, and what about parts?1948–19521963–1968Ahead (a fact, not an advantage)The URSUS C-328 is newer: production began 15 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The URSUS C-328 has 15% more top speed (3.0 km/h / 1.9 mph) than the Hermann Lanz D 28 (TD) (both top speed forward, as stated by the source).
  • The URSUS C-328 is newer: production began 15 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on drive: all two-wheel drive.
  • Not comparable on power at the PTO shaft: the D 28 (TD) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the C-328 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, maximum permissible mass, a creeper range, PTO speeds and PTO independence.

← Every figure for both machines, side by side, with sources