11 material differences · fewer than 12
Tractor oneHanomag R 28 N1951–1953No measured PTO figureTractor twoMassey Ferguson MF 1301964–1972No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (32%); they were not built in overlapping years (1951–1953; 1964–1972). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | R 28 N | MF 130 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 28 hp | — | — |
| Engine declared | — | Perkins A 4.107 | — |
| Displacement declared | — | 1.75 L | — |
| Maximum torque declared | 99 lb·ft · 134 N·m | 77 lb·ft · 104 N·m | +29% R 28 N |
| Transmission | |||
| Top speed declared | 10.4 mph · 16.8 km/h | 12.4 mph · 20 km/h | +19% MF 130 |
| Clutch declared | Single-disc dry clutch | Pedal operated dry air-cooled MF double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 3.2 gpm · 12.0 L/min | 3.4 gpm · 13.0 L/min | +8% MF 130 |
| Pressure declared | — | 2,062–2,276 psi · 142–157 bar | — |
| Rear PTO speeds declared | 1430 | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,836 lb · 1,740 kg | 2,910 lb · 1,320 kg | +32% R 28 N |
| Maximum permissible mass declared | 4,740 lb · 2,150 kg | 5,512 lb · 2,500 kg | +16% MF 130 |
| Wheelbase declared | 70.9 in · 1,800 mm | 72.0 in · 1,830 mm | — |
| Length declared | 111.4 in · 2,830 mm | 112.2 in · 2,850 mm | — |
| Width declared | 62.2 in · 1,580 mm | 67.3 in · 1,710 mm | +8% MF 130 |
| Ground clearance declared | 12.2 in · 310 mm | 13.4 in · 340 mm | +10% MF 130 |
| Turning radius, braked declared | 10.2 ft · 3.10 m | 9.0 ft · 2.75 m | +13% R 28 N |
| Fuel tank declared | 50.7 qt · 48 L | 47.6 qt · 45 L | +7% R 28 N |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hanomag R 28 N sources
- Source: Traktorenlexikon, “Hanomag R 28 N”
Massey Ferguson MF 130 sources
- Source: Traktorenlexikon, “Massey Ferguson MF 30”
- Source: Traktorenlexikon, “Massey Ferguson MF 130 V”
- Source: Traktorenlexikon, “Massey Ferguson MF 130”