7 material differences · fewer than 12
Tractor oneHanomag Perfekt 401 (S)1964–1967No measured PTO figureTractor twoJohn Deere-LANZ 3101964–1968No measured PTO figure
Which should you choose?
Read our verdict on the Perfekt 401 (S) and the 310 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | Perfekt 401 (S) | 310 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 31 hp | 31.5 hp | — |
| Engine declared | Hanomag-Borgward D 301 R | John Deere 152 D 25 L | differs |
| Displacement declared | 1.80 L | 2.49 L | +39% 310 |
| Maximum torque declared | 73 lb·ft · 99 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 12.4–15.5 mph · 20–25 km/h | differs |
| Clutch declared | dual clutch by Fichtel & Sachs | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 5.0 gpm · 19.0 L/min | 4.1 gpm · 15.6 L/min | +22% Perfekt 401 (S) |
| Pressure declared | — | 2,190 psi · 151 bar | — |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,924 lb · 1,780 kg | 4,361 lb · 1,978 kg | +11% 310 |
| Maximum permissible mass declared | — | 5,864 lb · 2,660 kg | — |
| Wheelbase declared | 80.1 in · 2,035 mm | 81.6 in · 2,072 mm | — |
| Length declared | 133.1 in · 3,380 mm | 133.9 in · 3,400 mm | — |
| Width declared | 62.2 in · 1,580 mm | 62.2 in · 1,580 mm | — |
| Ground clearance declared | 15.7 in · 400 mm | 15.7 in · 400 mm | — |
| Turning radius, braked declared | 11.2 ft · 3.40 m | 10.8 ft · 3.30 m | — |
| Fuel tank declared | 49.7 qt · 47 L | 74.0 qt · 70 L | +49% 310 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hanomag Perfekt 401 (S) sources
- Source: Traktorenlexikon, “Hanomag Perfekt 401 (S)”
John Deere-LANZ 310 sources
- Source: Traktorenlexikon, “John Deere 310”