11 material differences · fewer than 12
Tractor oneHanomag C 2181957–1959No measured PTO figureTractor twoKramer KL 2001958–1967No measured PTO figure
Which should you choose?
Read our verdict on the C 218 and the KL 200 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | C 218 | KL 200 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 17.7 hp | 17.7 hp | — |
| Engine declared | Hanomag D 621 | — | — |
| Displacement declared | 1.02 L | — | — |
| Maximum torque declared | 58 lb·ft · 78 N·m | 64 lb·ft · 86 N·m | +10% KL 200 |
| Transmission | |||
| Top speed declared | 11.5 mph · 18.5 km/h | 12.4 mph · 20 km/h | +8% KL 200 |
| Clutch declared | Single-disc dry clutch from Fichtel & Sachs | Single-plate dry clutch from Fichtel & Sachs | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 3.7 gpm · 14.0 L/min | 4.2 gpm · 16 L/min | +14% KL 200 |
| Pressure declared | — | 1,707 psi · 118 bar | — |
| Rear PTO speeds declared | 1211 | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,031 lb · 1,375 kg | 2,800–3,153 lb · 1,270–1,430 kg | differs |
| Maximum permissible mass declared | — | 4,012 lb · 1,820 kg | — |
| Wheelbase declared | 77.2 in · 1,960 mm | 69.5–71.9 in · 1,765–1,825 mm | differs |
| Length declared | 122.0 in · 3,100 mm | 111.0–113.4 in · 2,820–2,880 mm | differs |
| Width declared | 63.0–73.2 in · 1,600–1,860 mm | 58.7–59.1 in · 1,490–1,500 mm | differs |
| Ground clearance declared | 15.7 in · 400 mm | 13.8–15.7 in · 350–400 mm | differs |
| Turning radius, braked declared | 8.5 ft · 2.60 m | — | — |
| Fuel tank declared | 47.6 qt · 45 L | 25.4 qt · 24 L | +88% C 218 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hanomag C 218 sources
- Source: Traktorenlexikon, “Hanomag C 218”
Kramer KL 200 sources
- Source: Traktorenlexikon, “Kramer KL 200”