11 material differences · fewer than 12
Tractor oneHanomag C 2181957–1959No measured PTO figureTractor twoJohn Deere-LANZ 1001962–1966No measured PTO figure
Which should you choose?
Read our verdict on the C 218 and the 100 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | C 218 | 100 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 17.7 hp | 17.7 hp | — |
| Engine declared | Hanomag D 621 | John Deere 204 | differs |
| Displacement declared | 1.02 L | 1.18 L | +16% 100 |
| Maximum torque declared | 58 lb·ft · 78 N·m | — | — |
| Transmission | |||
| Top speed declared | 11.5 mph · 18.5 km/h | 12.4 mph · 20 km/h | +8% 100 |
| Clutch declared | Single-disc dry clutch from Fichtel & Sachs | pedal-operated dry Fichtel and Sachs single-plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 3.7 gpm · 14.0 L/min | 1.8 gpm · 7.0 L/min | +100% C 218 |
| Rear PTO speeds declared | 1211 | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,031 lb · 1,375 kg | 2,712 lb · 1,230 kg | +12% C 218 |
| Maximum permissible mass declared | — | 4,409 lb · 2,000 kg | — |
| Wheelbase declared | 77.2 in · 1,960 mm | 73.2 in · 1,860 mm | +5% C 218 |
| Length declared | 122.0 in · 3,100 mm | 122.8 in · 3,120 mm | — |
| Width declared | 63.0–73.2 in · 1,600–1,860 mm | 57.9 in · 1,470 mm | differs |
| Ground clearance declared | 15.7 in · 400 mm | 14.8 in · 375 mm | +7% C 218 |
| Turning radius, braked declared | 8.5 ft · 2.60 m | — | — |
| Fuel tank declared | 47.6 qt · 45 L | 31.7 qt · 30.0 L | +50% C 218 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hanomag C 218 sources
Source
- Source: Traktorenlexikon, “Hanomag C 218”
John Deere-LANZ 100 sources
Source
- Source: Traktorenlexikon, “John Deere-Lanz 100”