Güldner G 60 A or International Harvester 585?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the G 60 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 585 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Güldner G 60 A suits loader and hydraulic implement work better on this data: 10% (205 kg / 452 lb) more three-point lift.
- The International Harvester 585 suits heavy draft work (ploughing, cultivating) better on this data: four-wheel drive.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | G 60 A | 585 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 43.9 kW (58.9 hp)Traktorenlexikon, “Güldner G 60A” | 43.4 kW (58.2 hp)Traktorenlexikon, “IHC 585 (XL)” | Not comparableNot comparable on power at the PTO shaft: the G 60 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 585 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the G 60 A and the 585. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the G 60 A and the 585. |
| Which pumps more oil for implements? | — | — | No figureNo call on hydraulic flow: no figure on record for the G 60 A and the 585. |
| Which lifts more on the three-point hitch? | 2,200 kg (4,850 lb)Traktorenlexikon, “Güldner G 60A” | 1,995 kg (4,398 lb)Traktorenlexikon, “IHC 585 (XL)” | AheadThe Güldner G 60 A has 10% more lift (205 kg / 452 lb) than the International Harvester 585 (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 2,990 kg (6,592 lb)Traktorenlexikon, “Güldner G 60A” | 2,900 kg (6,393 lb)Traktorenlexikon, “IHC 585 (XL)” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 4,400 kg (9,700 lb)Traktorenlexikon, “Güldner G 60A” | — | No figureNo call on maximum permissible mass: no figure on record for the 585. |
| Which has the wider choice of gears? | 8Traktorenlexikon, “Güldner G 60A” | 8 to 16Traktorenlexikon, “IHC 585 (XL)” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | YesTraktorenlexikon, “Güldner G 60A” | — | No figureNo call on a creeper range: not stated for the 585. |
| Which is faster on the road? | 26.22 km/h (16.3 mph)Traktorenlexikon, “Güldner G 60A” | 25 km/h (15.5 mph)Traktorenlexikon, “IHC 585 (XL)” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Güldner G 60A” | 540/1000 rpmTraktorenlexikon, “IHC 585 (XL)” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | — | — | No figureNo call on PTO independence: not stated for the G 60 A and the 585. |
| Which drives on both axles? | 2WDTraktorenlexikon, “Güldner G 60A” | 2WD / 4WDTraktorenlexikon, “IHC 585 (XL)” | AheadThe International Harvester 585 is available with four-wheel drive; the Güldner G 60 A is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1968–1969 | 1981–1990 | Ahead (a fact, not an advantage)The International Harvester 585 is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Güldner G 60 A has 10% more lift (205 kg / 452 lb) than the International Harvester 585 (both lift at the hitch ends, as stated by the source).
- The International Harvester 585 is available with four-wheel drive; the Güldner G 60 A is two-wheel drive (as stated by the sources).
- The International Harvester 585 is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Not comparable on power at the PTO shaft: the G 60 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 585 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources