11 material differences · fewer than 12
Tractor oneGüldner G 60 (S)1968–1969No measured PTO figureTractor twoJohn Deere 2020 (A)1967–1972No measured PTO figure
Which should you choose?
Read our verdict on the G 60 (S) and the 2020 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | G 60 (S) | 2020 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 59.3 hp | 59.3 hp | — |
| Engine declared | Güldner 6 L 79 | John Deere M 5 BL 4 or 4202 DL-01 | differs |
| Displacement declared | 4.71 L | 3.32 L | +42% G 60 (S) |
| Maximum torque declared | 174 lb·ft · 236 N·m | — | — |
| Transmission | |||
| Top speed declared | 16.3 mph · 26.22 km/h | 12.4–18.6 mph · 20–30 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Closed centre | — |
| Pressure declared | 2,134 psi · 147 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,063 lb · 2,750 kg | 5,379 lb · 2,440 kg | +13% G 60 (S) |
| Maximum permissible mass declared | 9,700 lb · 4,400 kg | 8,818 lb · 4,000 kg | +10% G 60 (S) |
| Wheelbase declared | 91.1 in · 2,315 mm | 85.8 in · 2,180 mm | +6% G 60 (S) |
| Length declared | 155.7 in · 3,955 mm | 140.6 in · 3,570 mm | +11% G 60 (S) |
| Width declared | 73.4 in · 1,865 mm | 72.4 in · 1,840 mm | — |
| Ground clearance declared | 15.7 in · 400 mm | 13.8 in · 350 mm | +14% G 60 (S) |
| Turning radius, braked declared | 11.7 ft · 3.58 m | 10.7 ft · 3.26 m | +10% G 60 (S) |
| Fuel tank declared | 68.7 qt · 65 L | 78.0 qt · 73.8 L | +14% 2020 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Güldner G 60 (S) sources
- Source: Traktorenlexikon, “Güldner G 60”
- Source: Traktorenlexikon, “Güldner G 75”
John Deere 2020 (A) sources
- Source: Traktorenlexikon, “John Deere 2020”