Güldner G 40A (S) or SAME DA 38 (DT)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the G 40A (S) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the DA 38 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Güldner G 40A (S) suits heavy draft work (ploughing, cultivating) better on this data: four-wheel drive.
- The SAME DA 38 (DT) suits road haulage better on this data: 25% (5.0 km/h / 3.1 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | G 40A (S) | DA 38 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 27.8 kW (37.3 hp)Traktorenlexikon, “Güldner G 40A” | 27.9 kW (37.4 hp)Traktorenlexikon, “SAME DA 38 (DT)” | Not comparableNot comparable on power at the PTO shaft: the G 40A (S) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the DA 38 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the G 40A (S) and the DA 38 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the G 40A (S) and the DA 38 (DT). |
| Which pumps more oil for implements? | — | 11.5 L/min (3.0 gpm)Traktorenlexikon, “SAME DA 38 (DT)” | No figureNo call on hydraulic flow: no figure on record for the G 40A (S). |
| Which lifts more on the three-point hitch? | 1,528 kg (3,369 lb)Traktorenlexikon, “Güldner G 40A” | — | No figureNo call on three-point lift: no figure on record for the DA 38 (DT). |
| Which is heavier, for traction? | 2,345 kg (5,170 lb)Traktorenlexikon, “Güldner G 40A” | 2,180 kg (4,806 lb)Traktorenlexikon, “SAME DA 38 (DT)” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the G 40A (S) and the DA 38 (DT). |
| Which has the wider choice of gears? | 8Traktorenlexikon, “Güldner G 40A” | 5Traktorenlexikon, “SAME DA 38 (DT)” | AheadThe Güldner G 40A (S) has 60% more forward gears (3 gears) than the SAME DA 38 (DT) (both forward gears, as stated by the source). |
| Which offers a creeper range? | YesTraktorenlexikon, “Güldner G 40A” | — | No figureNo call on a creeper range: not stated for the DA 38 (DT). |
| Which is faster on the road? | 20 km/h (12.4 mph)Traktorenlexikon, “Güldner G 40A” | 25 km/h (15.5 mph)Traktorenlexikon, “SAME DA 38 (DT)” | AheadThe SAME DA 38 (DT) has 25% more top speed (5.0 km/h / 3.1 mph) than the Güldner G 40A (S) (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 540/1150 rpmTraktorenlexikon, “Güldner G 40A” | 585 rpmTraktorenlexikon, “SAME DA 38 (DT)” | No figureNo call on PTO speeds: no standard PTO speed stated for the DA 38 (DT). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Güldner G 40A” | — | No figureNo call on PTO independence: not stated for the DA 38 (DT). |
| Which drives on both axles? | 4WDTraktorenlexikon, “Güldner G 40A” | 2WDTraktorenlexikon, “SAME DA 38 (DT)” | AheadThe Güldner G 40A (S) is available with four-wheel drive; the SAME DA 38 (DT) is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1963–1969 | 1952–1957 | Ahead (a fact, not an advantage)The Güldner G 40A (S) is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Güldner G 40A (S) has 60% more forward gears (3 gears) than the SAME DA 38 (DT) (both forward gears, as stated by the source).
- The SAME DA 38 (DT) has 25% more top speed (5.0 km/h / 3.1 mph) than the Güldner G 40A (S) (both top speed forward, as stated by the source).
- The Güldner G 40A (S) is available with four-wheel drive; the SAME DA 38 (DT) is two-wheel drive (as stated by the sources).
- The Güldner G 40A (S) is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Not comparable on power at the PTO shaft: the G 40A (S) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the DA 38 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, maximum permissible mass, a creeper range, PTO speeds and PTO independence.
← Every figure for both machines, side by side, with sources