8 material differences · fewer than 12
Tractor oneGüldner G 40 (Toledo)1962No measured PTO figureTractor twoSteyr 1901964–1966No measured PTO figure
Which should you choose?
Read our verdict on the G 40 (Toledo) and the 190 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | G 40 (Toledo) | 190 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 35.34 hp | 35.5 hp | — |
| Engine declared | Güldner 3 L 79 | Steyr WD-306 | differs |
| Displacement declared | 2.36 L | 2.26 L | — |
| Maximum torque declared | 95 lb·ft · 128 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4–18.6 mph · 20–30 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Foot-operated dry double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 4.2 gpm · 16.0 L/min | — | — |
| Pressure declared | 2,489 psi · 172 bar | 2,134 psi · 147 bar | +17% G 40 (Toledo) |
| Rear PTO speeds declared | 540/1150 rpm | 587 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,442 lb · 2,015 kg | 3,726 lb · 1,690 kg | +19% G 40 (Toledo) |
| Maximum permissible mass declared | 4,526 lb · 2,053 kg | — | — |
| Wheelbase declared | 76.9 in · 1,954 mm | 73.6 in · 1,870 mm | — |
| Length declared | 120.9 in · 3,070 mm | 127.4 in · 3,235 mm | +5% 190 |
| Width declared | 61.9 in · 1,572 mm | 64.6 in · 1,640 mm | — |
| Ground clearance declared | 15.7 in · 400 mm | 13.0 in · 330 mm | +21% G 40 (Toledo) |
| Turning radius, braked declared | 9.8 ft · 3.00 m | 15.1 ft · 4.60 m | +53% 190 |
| Fuel tank declared | 50.7 qt · 48 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Güldner G 40 (Toledo) sources
- Source: Traktorenlexikon, “Güldner G 40 Toledo”
Steyr 190 sources
- Source: Traktorenlexikon, “Steyr 190”