Güldner G 40 (Toledo) or RÖHR R 35?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the G 40 (Toledo) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the R 35 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | G 40 (Toledo) | R 35 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 26.35 kW (35.34 hp)Traktorenlexikon, “Güldner G 40 Toledo” | 26.5 kW (35.5 hp)Traktorenlexikon, “Röhr R 35” | Not comparableNot comparable on power at the PTO shaft: the G 40 (Toledo) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the R 35 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the G 40 (Toledo) and the R 35. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the G 40 (Toledo) and the R 35. |
| Which pumps more oil for implements? | 16.0 L/min (4.2 gpm)Traktorenlexikon, “Güldner G 40 Toledo” | — | No figureNo call on hydraulic flow: no figure on record for the R 35. |
| Which lifts more on the three-point hitch? | 1,700 kg (3,748 lb)Traktorenlexikon, “Güldner G 40 Toledo” | — | No figureNo call on three-point lift: no figure on record for the R 35. |
| Which is heavier, for traction? | 2,015 kg (4,442 lb)Traktorenlexikon, “Güldner G 40 Toledo” | 1,890 kg (4,167 lb)Traktorenlexikon, “Röhr R 35” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 2,053 kg (4,526 lb)Traktorenlexikon, “Güldner G 40 Toledo” | — | No figureNo call on maximum permissible mass: no figure on record for the R 35. |
| Which has the wider choice of gears? | 8Traktorenlexikon, “Güldner G 40 Toledo” | 5 to 6Traktorenlexikon, “Röhr R 35” | AheadThe Güldner G 40 (Toledo) has 33% more forward gears (2 gears) than the RÖHR R 35 (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the G 40 (Toledo) and the R 35. |
| Which is faster on the road? | 20 km/h (12.4 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “Güldner G 40 Toledo” | 20 km/h (12.4 mph)Traktorenlexikon, “Röhr R 35” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1150 rpmTraktorenlexikon, “Güldner G 40 Toledo” | 540 rpmTraktorenlexikon, “Röhr R 35” | EvenEven on PTO speeds: the same speeds (540 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Güldner G 40 Toledo” | dependent (stops with the clutch)Traktorenlexikon, “Röhr R 35” | AheadThe Güldner G 40 (Toledo) has an independent PTO; the RÖHR R 35’s is dependent (stops with the clutch). |
| Which drives on both axles? | 2WDTraktorenlexikon, “Güldner G 40 Toledo” | 2WDTraktorenlexikon, “Röhr R 35” | EvenEven on drive: all two-wheel drive. |
| Which is newer, and what about parts? | 1962 | 1949 | Ahead (a fact, not an advantage)The Güldner G 40 (Toledo) is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Güldner G 40 (Toledo) has 33% more forward gears (2 gears) than the RÖHR R 35 (both forward gears, as stated by the source).
- The Güldner G 40 (Toledo) has an independent PTO; the RÖHR R 35’s is dependent (stops with the clutch).
- The Güldner G 40 (Toledo) is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540 rpm).
- Even on drive: all two-wheel drive.
- Not comparable on power at the PTO shaft: the G 40 (Toledo) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the R 35 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources