9 material differences · fewer than 12
Tractor oneGüldner G 35 (S)1967–1969No measured PTO figureTractor twoHanomag R 35 B1953–1957No measured PTO figure
Which should you choose?
Read our verdict on the G 35 (S) and the R 35 B → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | G 35 (S) | R 35 B | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34.3 hp | 34.3 hp | — |
| Engine declared | Güldner 3 L 79 | Hanomag D 28 | differs |
| Displacement declared | 2.36 L | 2.80 L | +19% R 35 B |
| Maximum torque declared | 95 lb·ft · 128 N·m | 99 lb·ft · 134 N·m | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 11.4–15.7 mph · 18.3–25.2 km/h | differs |
| Clutch declared | Pedal-operated dry double clutch by Fichtel & Sachs | Single-plate dry clutch from Fichtel & Sachs | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.2 gpm · 16.0 L/min | — |
| Pressure declared | 2,134 psi · 147 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 1615 | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,178 lb · 1,895 kg | 3,880 lb · 1,760 kg | +8% G 35 (S) |
| Maximum permissible mass declared | 7,055 lb · 3,200 kg | — | — |
| Wheelbase declared | 76.9 in · 1,954 mm | 70.9 in · 1,800 mm | +9% G 35 (S) |
| Length declared | 128.0 in · 3,250 mm | 110.6 in · 2,810 mm | +16% G 35 (S) |
| Width declared | 65.4 in · 1,662 mm | 65.0 in · 1,650 mm | — |
| Ground clearance declared | 15.7 in · 400 mm | 14.2 in · 360 mm | +11% G 35 (S) |
| Turning radius, braked declared | 10.3 ft · 3.15 m | 10.2 ft · 3.10 m | — |
| Fuel tank declared | — | 47.6 qt · 45 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Güldner G 35 (S) sources
- Source: Traktorenlexikon, “Güldner G 35”
- Source: Traktorenlexikon, “Güldner G 40 Toledo”
Hanomag R 35 B sources
- Source: Traktorenlexikon, “Hanomag R 35 B”