Ford 9500 vs International Harvester 806
8 material differences · fewer than 12
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1968–1975; 1963–1967). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 9500 | 806 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 94 hp | 93.7 hp | — |
| Engine declared | — | INTERNATIONAL HARVESTER C-301 | — |
| Maximum torque declared | 231 lb·ft · 314 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 18.6 mph · 30 km/h | +50% 806 |
| Clutch declared | Single-plate dry clutch | Pedal-operated dry single-plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 6.0 gpm · 22.7 L/min | — | — |
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,047 lb · 3,650 kg | 8,459 lb · 3,837 kg | — |
| Wheelbase declared | 105.9 in · 2,690 mm | 91.0 in · 2,311 mm | +16% 9500 |
| Length declared | 159.1 in · 4,040 mm | 161.0 in · 4,089 mm | — |
| Width declared | 76.8 in · 1,950 mm | 110.0 in · 2,794 mm | +43% 806 |
| Height declared | 69.7 in · 1,770 mm | 81.0 in · 2,057 mm | +16% 806 |
| Ground clearance declared | 19.7 in · 500 mm | 17.0 in · 432 mm | +16% 9500 |
| Turning radius, braked declared | 13.0 ft · 3.95 m | — | — |
| Fuel tank declared | 79.9 qt · 75.6 L | 168.0 qt · 159.0 L | +110% 806 |
Ford 9500 sources
Source
- Source: Traktorenlexikon, “Ford 9500”
International Harvester 806 sources
Source
- Source: Traktorenlexikon, “IHC 806”