5 material differences · fewer than 12
Tractor oneFord 3055 (A)1971–1975No measured PTO figureTractor twoFord 4110 (A)1981–1991No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (38%); they were not built in overlapping years (1971–1975; 1981–1991). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 3055 (A) | 4110 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 53.2 hp | 53.2 hp | — |
| Engine declared | Ford 182 DF | — | — |
| Displacement declared | 3.00 L | — | — |
| Maximum torque declared | 139 lb·ft · 188 N·m | 139 lb·ft · 189 N·m | — |
| Transmission | |||
| Top speed declared | 12.4–15.5 mph · 20–25 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Pedal-operated dry single-plate clutch | Foot-operated dry Borg & Beck single-disc clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 8.1 gpm · 30.7 L/min | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,224 lb · 1,916 kg | 5,820 lb · 2,640 kg | +38% 4110 (A) |
| Wheelbase declared | 77.2 in · 1,960 mm | 77.5 in · 1,969 mm | — |
| Length declared | 135.0 in · 3,430 mm | 135.8 in · 3,450 mm | — |
| Width declared | 72.0 in · 1,830 mm | 68.5–92.5 in · 1,740–2,350 mm | differs |
| Ground clearance declared | 19.5 in · 495 mm | 13.9 in · 354 mm | +40% 3055 (A) |
| Turning radius, braked declared | — | 10.0 ft · 3.05 m | — |
| Fuel tank declared | 51.8 qt · 49 L | 52.0 qt · 49.2 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Ford 3055 (A) sources
- Source: Traktorenlexikon, “Ford 3055”
Ford 4110 (A) sources
- Source: Traktorenlexikon, “Ford 4110”