7 material differences · fewer than 12
Tractor oneFord 26101981–1983No measured PTO figureTractor twoSOMECA 450 (DT)1968–1971No measured PTO figure
Which should you choose?
Read our verdict on the 2610 and the 450 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 2610 | 450 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 40.5 hp | 40.5 hp | — |
| Engine declared | — | O.M.-FIAT 8035.01.200 or 300 | — |
| Displacement declared | — | 2.34 L | — |
| Maximum torque declared | 113 lb·ft · 153.5 N·m | 105 lb·ft · 143 N·m | +7% 2610 |
| Transmission | |||
| Top speed declared | 18.0 mph · 29 km/h | 15.5 mph · 25 km/h | +16% 2610 |
| Clutch declared | Pedal-operated, dry Borg & Beck double clutch | Pedal operated dry FEREDO double clutch type 10 inch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 5.8 gpm · 21.8 L/min | 5.8 gpm · 21.8 L/min | — |
| Pressure declared | — | 2,843 psi · 196 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,977 lb · 1,804 kg | 3,836 lb · 1,740 kg | — |
| Wheelbase declared | 75.8 in · 1,925 mm | 75.6 in · 1,920 mm | — |
| Length declared | 128.0 in · 3,250 mm | 122.0 in · 3,100 mm | — |
| Width declared | 64.6–88.6 in · 1,640–2,250 mm | 59.8–87.4 in · 1,520–2,220 mm | differs |
| Ground clearance declared | 9.7 in · 247 mm | 14.2 in · 360 mm | +46% 450 (DT) |
| Turning radius, braked declared | 10.1 ft · 3.07 m | 9.4 ft · 2.86 m | +7% 2610 |
| Fuel tank declared | 52.0 qt · 49.2 L | 57.1 qt · 54.0 L | +10% 450 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Ford 2610 sources
- Source: Traktorenlexikon, “Ford 2610”
SOMECA 450 (DT) sources
- Source: Traktorenlexikon, “Someca 450”