13 material differences
Tractor oneFord 1720 (A)1987–2000No measured PTO figureTractor twoLamborghini 250 DT1992–2003No measured PTO figure
Which should you choose?
Read our verdict on the 1720 (A) and the 250 DT → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
13 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | 1720 (A) | 250 DT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 26.1 hp | 24.7 hp | +6% 1720 (A) |
| Engine declared | ISHIKAWAJIMA-SHIBAURA N-843 | MITSUBISHI K3 F-D | differs |
| Displacement declared | 1.50 L | 1.12 L | +34% 1720 (A) |
| Maximum torque declared | 63 lb·ft · 85.2 N·m | 44 lb·ft · 59.8 N·m | +42% 1720 (A) |
| Transmission | |||
| Top speed declared | 13.7 mph · 22 km/h | 15.5 mph · 25 km/h | +14% 250 DT |
| Clutch declared | pedal-operated dry Daikin double clutch | Pedal operated dry single disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 7.9 gpm · 29.9 L/min | 2.2 gpm · 8.3 L/min | +260% 1720 (A) |
| Pressure declared | — | 1,305 psi · 90 bar | — |
| Three-point lift, at the coupling points declared | 2,441 lb · 1,107 kg | 2,646 lb · 1,200 kg | +8% 250 DT |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,491 lb · 1,130 kg | 2,138 lb · 970 kg | +16% 1720 (A) |
| Maximum permissible mass declared | — | 4,630 lb · 2,100 kg | — |
| Wheelbase declared | 65.0 in · 1,650 mm | 60.6 in · 1,540 mm | +7% 1720 (A) |
| Length declared | 121.2 in · 3,079 mm | 105.9 in · 2,690 mm | +14% 1720 (A) |
| Width declared | 54.7–70.0 in · 1,390–1,778 mm | 44.1–50.4 in · 1,120–1,280 mm | differs |
| Ground clearance declared | 11.8 in · 300 mm | 11.4 in · 290 mm | — |
| Turning radius, braked declared | — | 8.5 ft · 2.60 m | — |
| Fuel tank declared | 33.8 qt · 32.0 L | 30.6 qt · 29.0 L | +10% 1720 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Ford 1720 (A) sources
Source
- Source: Traktorenlexikon, “Ford 1720”
Lamborghini 250 DT sources
Source
- Source: Traktorenlexikon, “Lamborghini Runner 250 DT A”
- Source: Traktorenlexikon, “Hürlimann Prince 325”