Fiat TS 100 (DT) or John Deere 3050 (A)?
Which should you choose?
The figures split: the Fiat TS 100 (DT) is ahead on hydraulic flow; the John Deere 3050 (A) is ahead on maximum permissible mass.
- The Fiat TS 100 (DT) suits loader and hydraulic implement work better on this data: 64% (33.7 L/min / 8.9 gpm) more hydraulic flow.
- The John Deere 3050 (A) suits road haulage better on this data: 12% (700 kg / 1,543 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | TS 100 (DT) | 3050 (A) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 62.0 kW (83.1 hp)Traktorenlexikon, “Fiatagri TS100” | 62 kW (83 hp)Traktorenlexikon, “John Deere 3050” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the TS 100 (DT) and the 3050 (A). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the TS 100 (DT) and the 3050 (A). |
| Which pumps more oil for implements? | 86.0 L/min (22.7 gpm)Traktorenlexikon, “Fiatagri TS100” | 52.3 L/min (13.8 gpm)Traktorenlexikon, “John Deere 3050” | AheadThe Fiat TS 100 (DT) has 64% more hydraulic flow (33.7 L/min / 8.9 gpm) than the John Deere 3050 (A) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 4,294 kg (9,467 lb)Traktorenlexikon, “Fiatagri TS100” | 4,526 kg (9,978 lb)Traktorenlexikon, “John Deere 3050” | EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which is heavier, for traction? | 3,929 kg (8,662 lb)Traktorenlexikon, “Fiatagri TS100” | 3,920 kg (8,642 lb)Traktorenlexikon, “John Deere 3050” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 6,000 kg (13,228 lb)Traktorenlexikon, “Fiatagri TS100” | 6,700 kg (14,771 lb)Traktorenlexikon, “John Deere 3050” | AheadThe John Deere 3050 (A) has 12% higher maximum permissible mass (700 kg / 1,543 lb) than the Fiat TS 100 (DT) (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 12 to 24Traktorenlexikon, “Fiatagri TS100” | 8 to 16Traktorenlexikon, “John Deere 3050” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the TS 100 (DT) and the 3050 (A). |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiatagri TS100” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “John Deere 3050” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Fiatagri TS100” | 540/1000 rpmTraktorenlexikon, “John Deere 3050” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Fiatagri TS100” | independentTraktorenlexikon, “John Deere 3050” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Fiatagri TS100” | 2WD / 4WDTraktorenlexikon, “John Deere 3050” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1997–2003 | 1986–1993 | Ahead (a fact, not an advantage)The Fiat TS 100 (DT) is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Fiat TS 100 (DT) has 64% more hydraulic flow (33.7 L/min / 8.9 gpm) than the John Deere 3050 (A) (both pump flow, as stated by the source).
- The John Deere 3050 (A) has 12% higher maximum permissible mass (700 kg / 1,543 lb) than the Fiat TS 100 (DT) (both maximum permissible mass, as stated by the source).
- The Fiat TS 100 (DT) is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power and a creeper range.
← Every figure for both machines, side by side, with sources