6 material differences · fewer than 12
Tractor oneFiat 940 (DT)1978–1979No measured PTO figureTractor twoHürlimann T-9200 (A)1976–1979No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their power is identical, with the same weight or the same engine, which usually means one machine sold under two names; any difference below comes from how each source describes it. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 940 (DT) | T-9200 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 90.8 hp | 90.7 hp | — |
| Engine declared | O.M.-FIAT CO 3/80 | Hürlimann D-310 T | differs |
| Displacement declared | 4.94 L | 4.95 L | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Dry FEREDO double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 10.0 gpm · 38.0 L/min | 13.7 gpm · 52.0 L/min | +37% T-9200 (A) |
| Pressure declared | 2,901 psi · 200 bar | 2,987 psi · 206 bar | — |
| Rear PTO speeds declared | — | 540/1050 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,708 lb · 3,950 kg | 6,967 lb · 3,160 kg | +25% 940 (DT) |
| Wheelbase declared | 93.3 in · 2,370 mm | 93.7 in · 2,380 mm | — |
| Length declared | 159.4 in · 4,050 mm | 147.6 in · 3,750 mm | +8% 940 (DT) |
| Width declared | 76.2–99.7 in · 1,935–2,532 mm | 75.6 in · 1,920 mm | differs |
| Ground clearance declared | 22.4 in · 570 mm | — | — |
| Turning radius, braked declared | 12.6 ft · 3.84 m | — | — |
| Fuel tank declared | 95.1 qt · 90.0 L | 58.1 qt · 55.0 L | +64% 940 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 940 (DT) sources
- Source: Traktorenlexikon, “Fiat 940/940 DT”
- Source: Traktorenlexikon, “Someca 940”
Hürlimann T-9200 (A) sources
- Source: Traktorenlexikon, “Hürlimann T-9200”