10 material differences · fewer than 12
Tractor oneFiat 82-861992–2000No measured PTO figureTractor twoVALMET 8001997–2002No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (68%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | 82-86 | 800 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 79 hp | 79 hp | — |
| Engine declared | — | VALMET 420 DS or DSRE | — |
| Displacement declared | — | 4.40 L | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Constant flow | — |
| Pump flow declared | 10.6 gpm · 40.0 L/min | 14.7 gpm · 55.7 L/min | +39% 800 |
| Pressure declared | 3,118 psi · 215 bar | 2,901 psi · 200 bar | +8% 82-86 |
| Rear PTO speeds declared | 540 rpm | 540E/540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,381 lb · 1,987 kg | 7,341 lb · 3,330 kg | +68% 800 |
| Wheelbase declared | 77.1 in · 1,959 mm | 88.3 in · 2,244 mm | +15% 800 |
| Length declared | 133.5 in · 3,390 mm | 152.6 in · 3,877 mm | +14% 800 |
| Width declared | 60.6 in · 1,540 mm | 85.7 in · 2,177 mm | +41% 800 |
| Ground clearance declared | 15.0 in · 380 mm | 19.9 in · 505 mm | +33% 800 |
| Turning radius, braked declared | — | 15.7 ft · 4.80 m | — |
| Fuel tank declared | 47.6 qt · 45.0 L | 83.5 qt · 79.0 L | +76% 800 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 82-86 sources
- Source: Traktorenlexikon, “Fiatagri 82-86/82-86 DT”
- Source: Traktorenlexikon, “Fiatagri 82-86 F/82-86 F/DT”
VALMET 800 sources
- Source: Traktorenlexikon, “Valmet 800”