7 material differences · fewer than 12
Tractor oneFiat 715 (DT)1966–1969No measured PTO figureTractor twoSAME Leone 70 (DT)1967–1972No measured PTO figure
Which should you choose?
Read our verdict on the 715 (DT) and the Leone 70 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 715 (DT) | Leone 70 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 66.1 hp | 66.1 hp | — |
| Engine declared | O.M.-FIAT CO-2 D/70 | SAME DA 024-1004/V | differs |
| Displacement declared | — | 3.78 L | — |
| Maximum torque declared | — | 166 lb·ft · 225 N·m | — |
| Transmission | |||
| Top speed declared | 14.9 mph · 24 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Pedal operated dry FERODO double clutch | Pedal operated dry two-stage double clutch with coil springs | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 7.0 gpm · 26.5 L/min | 4.3 gpm · 16.3 L/min | +63% 715 (DT) |
| Pressure declared | 2,843 psi · 196 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 6,349 lb · 2,880 kg | 5,622 lb · 2,550 kg | +13% 715 (DT) |
| Wheelbase declared | 86.6 in · 2,200 mm | 85.8 in · 2,180 mm | — |
| Length declared | 146.9 in · 3,730 mm | 130.3 in · 3,310 mm | +13% 715 (DT) |
| Width declared | 77.2 in · 1,960 mm | 70.5–98.0 in · 1,790–2,490 mm | differs |
| Ground clearance declared | 18.1 in · 460 mm | 17.3 in · 440 mm | — |
| Turning radius, braked declared | 12.5 ft · 3.80 m | — | — |
| Fuel tank declared | 88.8 qt · 84.0 L | 96.2 qt · 91.0 L | +8% Leone 70 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 715 (DT) sources
- Source: Traktorenlexikon, “Fiat 715/715 DT”
SAME Leone 70 (DT) sources
- Source: Traktorenlexikon, “SAME Leone 70”